BEGA 34161 Ceiling and Wall Luminaire for Indoor Use Instruction Manual
- June 13, 2024
- BEGA
Table of Contents
28.22 Technical amendments reserved
Ceiling and wall luminaire for indoor use
34 161 IP 44
Instructions for use
Application
Ceiling and wall luminaire · indoor luminaire made of hand-blown opal glass,
satin matt and metal housing, for all lighting tasks.
They are ideal for places where a soft and uniform lighting distribution is
required. Luminaire with a high protection class.
Lamp
Luminaire with screw base E 27
Lamp output max. 60 W
This product contains light sources of energy efficiency class E
Supplied lamp
BEGA LED lamp 13548
LED 7 W · 805 lm · 2700 K dimmable
Supplied lamp
BEGA LED lamp 13586
LED 7 W · 805 lm · 3000 K dimmable
Luminaire efficiency: 62%
Detailed technical and lighting data for the lamps can be found in the data
sheets on our website.
Product description
Luminaire made of aluminium alloy and stainless steel, finish
Colour white Hand-blown opal glass, satin matt 1 fixing hole ø 5 mm 1 cable
entry for mains supply cable up to ø 10.5 mm max. 3 x 1.5
Connection terminal 2.5
Earth conductor connection
Lampholder E 27
Safety class I
Protection class IP 44
Protected against granular foreign bodies ≥ 1 mm and splash water
Impact strength IK02
Protection against mechanical impacts < 0.2 joule
– Safety mark
**** – Conformity mark
Weight: 0.9 kg
Safety
The installation and operation of this luminaire are subject to national
safety regulations. Installation and commissioning may only be carried out by
a qualified electrician.
The manufacturer accepts no liability for damage caused by improper use or
installation. If subsequent modifications are made to the luminaire, the
person responsible for these modifications shall be considered the
manufacturer.
Installation
Lead the mains supply cable through the cable entry into the luminaire back
housing.
If installed at the wall please note position of application “arrow down”.
Fix luminaire back housing with enclosed or any other suitable fixing material
onto the mounting surface.
It is imperative to use the enclosed gaskets.
Make earth conductor connection.
Push silicone sleeves over the lines and make electrical connection.
Insert lamp. Insert the opal glass into the lower spring clips, centralise and
push it into the upper spring clips.
Relamping · Maintenance
Disconnect the electrical installation.
Pull glass out of the spring clips and remove from the luminaire back housing.
Clean luminaire back housing and glass.
Use only solvent-free cleansers.
Change the lamp. Snap the glass into the lower spring clips, centralise and
push it into the upper spring clips.
Spares
| Spare glass | 11 002 363 .0R G |
|---|---|
| LED lamp 2700 K | 13 548 |
| LED lamp 3000 K | 13 586 |
| Lampholder | 63 000 052 |
BEGA Gantenbrink-Leuchten KG
Postfach 31 60
58689 Menden
info@bega.com
www.bega.com