Dimplex 1500W Mini Cube Electric Fire Heater Instructions

Dimplex 1500W Mini Cube Electric Fire Heater

Dimension

Important Safety Advice

• When using electrical appliances, basic precautions should be followed to reduce the risk of fire, electric shock, and injury to persons, including the following:
• Do not use it there are visible signs of damage, check immediately with the supplier before installation and operation.
• Do not use this appliance in the immediate surroundings of a bath, shower or swimming pool.
• Do not use outdoors.
• Do not use this heater if it has been dropped.
• This appliance must not be located immediately above or below a fixed socket outlet or connection box.
• WARNING : The appliance carries the Warning Symbol indicating that it must not be covered or has a Do not cover label. Do not cover or obstruct in any way the heat outlet grille located
• underneath the appliance, overheating will result if the appliance is accidentally covered. Do not place material or garments on the appliance, or obstruct the air circulation around the appliance, for instance by curtains or furniture, as this could cause overheating and a fire risk.
• In the event of a fault unplug the heater. Unplug the appliance when not required for long periods.The supply cord must be placed on the right hand side of the heater away from the heat outlet underneath the appliance.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the
• appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
• Cleaning and user maintenance shall not be made by Children.
• The appliance must be positioned so that the plug is accessible.
• If the supply cord is damaged it must be replaced by the manufacturer or service agent or similarly qualified person in order to avoid a hazard.
• Use this applaince on a horizontal and stable surface, or fix to the wall, as applicable.
• Although this heater complies with safety standards, we do not recommend its use on deep pile carpets or on long hair type of rugs.
• Warning: Do not use the heater in small rooms when they are occupied by persons not capable of leaving the room on their own, unless constant supervision is provided.
• CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this appliance must not be supplied through an external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility.
• Warning: To reduce the risk of fire, keep textiles,curtains, or other flammable material a minimum distance of 1m from the air outlet.
• CAUTION – Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present.

This instruction can be found at www.dimplex.com.au & www.dimplex.co.nz

Technical Information

Model No: MCF15, MINICUBE| | | | |
---|---|---|---|---|---
Heat Output| | 230V| | 240V|
Nominal Heat Output| P Nom| 1.3| –| 1.4| kW
Minimum Heat Output| P min| 0.7| –| 0.7| kW
Maximum Continous Heat Output| P max,c| 1.3| –| 1.4| kW

Auxiliary Electricity Consumption

In Standby mode| el SB| 0.86| –| 0.90| W

General

Unpack the heater carefully and retain the packaging for possible future use, in the event of moving or returning the fire to your supplier.
The fire incorporates a flame effect, which can be used with or without heating, so that the comforting effect may be enjoyed at any time of the year. Using the flame effect on its own requires very little electricity.
These models are designed to be free standing and are normally positioned against a wall.
Before connecting the heater check that the supply voltage is the same as that stated on the heater.
Please note: Used in an environment where background noise is very low, it may be possible to hear a sound which is related to the operation of the flame effect.
This is normal and should not be a cause for concern.

Electrical connection

WARNING – THIS APPLIANCE MUST BE EARTHED.
This heater must be used on an AC ~ supply only and the voltage marked on the heater must correspond to the supply voltage. Before switching on, please read the safety warnings and operating Instructions.

Controls – see Fig. 2
Three switches provide a choice of heat settings. A switch is in the ON position when the side with the markings on (i.e. I, I, or II) is pushed in.

Switch 1 (I) Controls the electricity supply to the heater and the flame effect.
Note: This switch must be in the ON (I) position for heater to operate with or without heat.

Switch 2 (I) Provides 750W heat output
Switch 3 (II)  Provides 1500W heat output with switch 2 in the ON positon also.

Thermal Safety Cut-out

The built-in overheat cut-out switches off the appliance automatically in the event of a fault. Switch off the appliance or disconnect the mains plug from the socket. After a short cooling down phase, the appliance is ready for use again. If the fault should occur again, see your local dealer.

WARNING : This heater is not equipped with a device to control the room temperature. Do not use this heater in small rooms when they are occupied by persons not capable of leaving the room on their own, unless constant supervision is provided.
Maintenance

WARNING : ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE ATTEMPTING ANY MAINTENANCE.

Light Emitting Diode
This fire is fitted with LED (Light Emitting Diode) bulbs in place of traditional incandescent bulbs. These generate the same light levels as traditional bulbs, but use a fraction of the energy consumed.

Recycling
At the end of the electrical product’s useful life it should not be disposed of with household waste.
Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice in your country.

Cleaning

WARNING – ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE CLEANING THE HEATER.
For general cleaning use a soft clean duster – never use abrasive cleaners. The glass viewing screen should be cleaned carefully with a soft cloth. DO NOT use proprietary glass cleaners.
To remove any accumulation of dust or fluff the soft brush attachment of a vacuum cleaner should occasionally be used to clean the outlet grille of the fan heater.
After Sales Service
Please see the separate Warranty leaflet for details of your Warranty & After Sales Service including contact details.
Should you require after sales information or assistance with this product, please contact Glen Dimplex Australia on 1300 556 816 (AUS) / 09 274 8265 (NZ) or visit our website at www.dimplex.com.au (AUS) / www.dimplex.co.nz (NZ).

Glen Dimplex Australia
8 Lakeview Drive,Scoresby, VIC 3179,
Australia
www.dimplex.com.au sales@glendimplex.com.au
Ph: 1300 556 816

Glen Dimplex Australasia Ltd. 38 Harris Road,
East Tamaki,
Auckland 2013
New Zealand
www.dimplex.co.nz
sales@glendimplex.co.nz
Ph: +61 9 274 8265

This product is protected by Intellectual property rights and patents owned by the Glen Dimplex Group on an international basis. The Glen Dimplex Group of Companies will actively protect these rights.

Glen Dimplex. All rights reserved. Material contained in this publication may not be reproduced in whole or in part, without prior permission in writing from Glen Dimplex.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>