BEGA 50536.1 LED Ceiling and Wall Luminaire for Indoor Use Instruction Manual

BEGA 50536.1 LED Ceiling and Wall Luminaire for Indoor Use

Product Information

This product is a luminaire that requires installation and operation according to national safety regulations. It should only be installed and commissioned by a qualified electrician. The manufacturer does not accept liability for any damage caused by improper use or installation. Modifications to the luminaire should only be made by the person responsible for these modifications. The electronic components in the luminaire are protected against overvoltage according to DIN EN 61547. For additional protection against transients, it is recommended to use separate overvoltage protection components, which can be found on the manufacturer’s website at www.bega.com. The product features a lamp module with a connected wattage of 6.9 W and a luminaire connected wattage of 9 W. The rated temperature is 25°C, and the ambient temperature should not exceed 40°C. The colour temperature of the LED module is 3000 K, and the colour rendering index (CRI) is greater than 90. The module luminous flux is 1125 lm, while the luminaire luminous flux is 711 lm. The luminaire has a luminous efficiency of 79 lm/W. Spares for this product include a spare glass, LED power supply unit, LED module with a colour temperature of 3000 K, and a gasket. The corresponding part numbers are as follows:

• Spare glass: 11 002 864
• LED power supply unit: 11R G DEV-0279/500
• LED module 3000 K: LED-0338/930
• Gasket: 83 001 313

Product Usage Instructions

1. Ensure that the luminaire is installed and operated in accordance with national safety regulations.
2. Only a qualified electrician should perform the installation and commissioning of the luminaire.
3. Avoid making any modifications to the luminaire unless you are the person responsible for these modifications.
4. For additional protection against overvoltage and transients, consider using separate overvoltage protection components available on the manufacturer’s website.
5. The lamp module and the luminaire have connected wattages of 6.9 W and 9 W, respectively.
6. Ensure that the rated temperature of the luminaire does not exceed 25°C and the ambient temperature does not exceed 40°C.
7. The LED module has a colour temperature of 3000 K and a colour rendering index (CRI) greater than 90.
8. The module luminous flux is 1125 lm, and the luminaire luminous flux is 711 lm. The luminaire has a luminous efficiency of 79 lm/W.
9. If any spares are needed, refer to the part numbers provided in the user manual for the spare glass, LED power supply unit, LED module, and gasket.

DIMENSIONS

Instructions for use

Application

• Ceiling and wall luminaire· indoor luminaire with high protection class for a variety of lighting tasks.
• A luminaire made of die cast aluminium and crystal glass.

Product Description

• Aluminium alloy housing, finish Colour white
• Crystal glass, inside white
• Silicone gasket
• 2 mounting holes ø 4.5 mm
• Distance apart 150 mm
• 2 cable entries for through-wiring of mains supply cable ø 7-10.5 mm
• Connection terminal 2.5@
• Earth conductor connection
• LED power supply unit
• 220-240 V x 0/50-60 Hz
• DC 176-280 V
• BEGA Thermal Switch®
• Temporary thermal shutdown to protect temperature-sensitive components
• Safety class I
• Protection class IP 65
• Dust-tight and protection against water jets Impact strength IK06
• Protection against mechanical
• impacts < 1 joule
•  – Safety mark
•   – Conformity mark
• Weight: 1.8 kg

This product contains light sources of energy efficiency class(es) D

Safety

• The installation and operation of this luminaire are subject to national safety regulations. Installation and commissioning may only be carried out by a qualified electrician.
• The manufacturer accepts no liability for damage caused by improper use or installation. If subsequent modifications are made to the luminaire, the person responsible for these modifications shall be considered the manufacturer.

Overvoltage protection

• The electronic components installed in the luminaire are protected against overvoltage in accordance with DIN EN 61547.
• To achieve an additional protection against e. g. transients, etc. we recommend separate overvoltage protection components.
• You can find them on our website at www.bega.com.

Lamp

• Module connected wattage 6.9 W
• Luminaire connected wattage 9 W
• Rated temperature ta = 25 °C
• Ambient temperature ta max = 40 °C

50 536.1 K3

• Module designation LED-0338/930
• Colour temperature 3000 K
• Colour rendering index CRI > 90
• Module luminous flux 1125 lm
• Luminaire luminous flux 711 lm
• Luminaire luminous efficiency 79 lm / W

Installation

• Remove luminaire housing with glass from luminaire base by turning it counter-clockwise. LED are high-quality electronic components! Please avoid touching the light output opening of the LED directly during installation or relamping.
• Disassemble LED module.
• Lead the mains supply cable through the cable entry into the luminaire back housing.
• Fix luminaire base with enclosed or any other suitable fixing material onto the mounting surface.
• Be sure to use the gasket rings supplied. Make the earth conductor connection and the electrical connection.
• Assemble LED module.
• Make sure that gasket is positioned correctly. Place luminaire housing with glass onto the luminaire base and turn it clockwise as far as it will go.

Cleaning · Maintenance

• Clean luminaire regularly with solvent-free cleansers from dirt.

Replacing the LED module

• The designation of the LED module is noted on a label in the luminaire.
• The light colour and light output of BEGA replacement modules correspond to those of the modules originally fitted.
• The module can be replaced by qualified persons using standard tools.
• Disconnect the system and open the luminaire. Please follow the installation instructions for the LED module.
• Inspect and, if necessary, replace the luminaire gaskets.
• Defective glass must be replaced.
• Close the luminaire.

Spares

• Spare glass 11 002 864 11R G
• LED power supply unit DEV-0279/500
• LED module 3000 K LED-0338/930
• Gasket 83 001 313

BEGA Gantenbrink-Leuchten KG · Postfach 31 60 · 58689 Menden · info@bega.com · www.bega.com

References

• BEGA · Das gute Licht.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>