Phillips Connect Technologies LCA01 Bluetooth GPIO Detector Instructions
- June 6, 2024
- Phillips Connect Technologies
Table of Contents
Connect Technologies LCA01 Bluetooth GPIO Detector
Instructions
Step 1 – mount Smart 7 to trailer
Step 2 – run harness, with approximately 2” of jacket fed through Smart 7
grommet
Step 3 – connect ring terminals on the main harness to the bottom row of
studs, as shown in Figure 1
Step 4 – connect .180 male bullet from the main harness to female .180 bullet
in Smart 7 to supply red
power to ABS, as shown in Figure 1.
Step 5 – run harnesses for Automatic Tire Inflation System, with approximately
2” of jacket fed through Smart 7 grommet.
Step 6 – connect ATIS wiring and LampCheck ATIS as shown in Figure 2
Note – LampCheck ATIS ground wire will be pre-installed on the ground post.
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Radiation Exposure Statement
To comply with FCC RF exposure compliance requirements, this grant is
applicable to only mobile configurations. The antennas used for this
transmitter must be installed to provide a separation distance of at least
20cm from all persons and must not be co-located or operating in conjunction
with any other antenna or transmitter.
ISED Statement
- This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device. The digital apparatus complies with Canadian CAN ICES-3 (B)/NMB-3(B).
This radio transmitter (ISED certification number: 25015-LCA01) has been approved by Industry Canada to operate with the antenna types listed with the maximum permissible gain indicated. Antenna types not included in this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>