APANTAC OG-12G-Demux-3G Card Set User Manual
- June 12, 2024
- APANTAC
Table of Contents
OG-12G-
Demux-3G
User Manual
WHAT’S IN THE BOX
There are three combinations of OG-DA-HDTV-SDI-UHD products
OG-12G-Demux-3G-SET-1
- 1 x OG-12G-Demux-3G-MB
- 1 x OG-12G-Demux-3G-RM
OG-12G-Demux-3G–SET-2
- 1 x OG-12G-Demux-3G-MB
- 1 x OG-12G-Demux-3G-RM
- 1 x SFP-SDI-12G-Tx for single mode fiber output
Key Features
- OGX/3.0 card-based form factor
- Dashboard control enabled
- Supports 1 x 12G SDI video input up to 4096×2160 or 1 x 3G SDI videoinput*
- Supports 4 x 3G output (quad link) in 2SI
- Analog audio output
- Passes HDR from input to output
- Optional 12G SDI fiber input via SFP
- Low power consumption – less than 15W
- 5-year limited warranty
Specifications
Description| 12G SDI to Quad 3G SDI Demuxer with a down converted 3G SDI
output
---|---
Input| 1 x 12G SDI (up to 4096×2160) input with optional fiber input
Output| 4 x 3G SDI outputs with 1 x 3G SDI down converted output
Optional Fiber input/output| SFP transceiver with LC connectors, single mode
up to 10 km
Analog audio Output| 3 Pin Pheonix Connector
Embedded audio Output| Up to 8 channels of audio from HDMI to SDI on the first
3G SDI link
Swtich| Switch between BNC and Fiber inputs
Control| Dashboard
Rear Modules
Accessories
SFP-SDI-12G-Tx
Dashboard Control
6.1 Getting Started
The Dashboard software is design to allow you to quickly access the feature
sets of openGear form factor cards on a simple User Interface. This section
will help you get up and running as quickly as possible.
6.2 Running Dashboard
Before you can successfully run the Dashboard software for the first time you
must first download it from https://www.opengear.tv/frame-and-control
/control-system/download/.
Run the downloaded setup file and choose an appropriate installation location
on your computer’s storage.
Now you can run the Dashboard by double clicking on the Dashboard icon.
6.3 OG-12G-Demux-3G Dashboard GUI
OG-12G-Deumx-3G is a very straight forward plug and play card.
The Dashboard interface only allows you to choose your input source;
BNC connector or Fiber input.
Appendex A
COPYRIGHT, TRADEMARK, and REGISTRATION
All rights reserved by APANTAC LCC, Beaverton, Oregon, USA. No part of this
document may be reproduced in any form or by any means without written
permission from the product manufacturer. Changes are periodically made to the
information in this document. They will be incorporated in subsequent
editions. The product manufacturer may make improvements and/or changes in the
product described in this document at any time.
All other trademark(s), copyright(s), and registered technologies mentioned in
this document are the properties of their repective owner(s).
WARRANTY STATEMENT
Apantac LLC (herein after referred to as “Apantac”) warrants to the original
purchaser of the products manufactured by Apantac (the “Product,”) will be
free from defects in material and workmanship for a period of three (3) year
from the date of shipment of the Product to the purchaser.
If the Product proves to be defective during the three (3) year warranty
period, the purchaser’s exclusive remedy and Apantac’s sole obligation under
this warranty is expressly limited, at Apantac’s sole option, to:
(a) repair the defective Product without charge for parts and labor or,
(b) provide a replacement in exchange for the defective Product or,
(c) if after a reasonable time, is unable to correct the defect or provide a
replacement Product in good working order, then the purchaser shall be
entitled to recover damages subject to the limitation of liability set forth
below.
Limitation of Liability
Apantac’s liability under this warranty shall not exceed the purchase price
paid for the defective product.
In no event shall Apantac be liable for any incidental, special or
consequential damages, including without limitation, loss of profits for any
breach of this warranty.
If Apantac replaces the defective Product with a replacement Product as
provided under the terms of this Warranty, in no event will the term of the
warranty on the replacement Product exceed the number of months remaining on
the warranty covering the defective Product.
Equipment manufactured by other suppliers and supplied by Apantac carries the
respective manufacturer’s warranty. Apantac assumes no warranty responsibility
either expressed or implied for equipment manufactured by others and supplied
by Apantac.
This hardware warranty shall not apply to any defect, failure, or damage:
a) Caused by improper use of the Product or inadequate maintenance and care of
the Product.
b) Resulting from attempts by those other than Apantac representatives to
install, repair, or service the Product.
c) Caused by installation of the Product in a hostile operating environment or
connection of the Product to incompatible equipment.
APANTAC LLC, 10200 SW ALLEN BLVD, BEAVERTON, OR 97005
INFO@APANTAC.COM,
TEL: +1 503 968 3000,
FAX: +1 503 389 7921
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>