SUNRICHER 0-10V BLE Fixture-Integrated Sensor-less Controller Owner’s Manual
- June 12, 2024
- SUNRICHER
Table of Contents
SUNRICHER 0-10V BLE Fixture-Integrated Sensor-less Controller Owner's Manual
Product info
Note
V+: Power supply
GND: Common port for V- & Dim-
DIM+: 0-10V signal port, represents 10V
Specification
Features
- Bluetooth to 0-10V signal converter,Bluetooth® mesh network
- Built-in 20mA 0-10V signal output · Mesh network, which has a much longer control distance, transmits received signals to neighboring devices
- All devices on 0-10V line are broadcast controlled
- Supporting our kinetic energy switches and EnOcean switches EWSSB and EWSDB
- In typical indoor environment, the typical range for wireless communication is 20m to 25m . Actual range is dependent on field installation.
- On-board antenna
- Waterproof grade: IP20
- 5 years warranty
Dimension
Application
Specifications
COMFORT & CONVENIENCE
- Low/High-end trimming
- Manual control
- Cost-effective solution for energy savings
- Auto and advanced demand response programs
- Zone linking
- In-node SchedulingINS) Function
- Working with kinetic switch and 0-10V dimmable drivers
ENVIRONMENT AND APPROBATION
- Operating temperature: 0°C to 45°C
- Agency approbations: UL Listed /FCC/ RoHS/ BQB …
- Warranty: 5 years
Warning
- DO NOT install with power applied to device
- DO NOT expose the device to moisture
Operation
- Do wiring according to connection diagram
- Kindly refer to Silvair commissioning User Manual for further pairing
- Press and hold down the “Reset” button on the controller over 5 seconds until the indicator flashes , which means it has been reset.
Wiring
Statement
FCC STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit dierent from that to which
the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation. Changes or modifications not expressly
approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
The distance between user and products should be no less than 20cm.
IC STATEMENT
This device complies with Industry Canada’s licence-exempt RSSs. Operation is
subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may
cause undesired operation of the device.
Update log
Subject to change without notice. Please contact us if you have any question.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>