VISUAL COMFORT ARN 3620 Hunlen Table Lamp Instruction Manual
- June 12, 2024
- VISUAL COMFORT
Table of Contents
VISUAL COMFORT ARN 3620 Hunlen Table Lamp
Product Information
Product Name: Hunlen Table Lamp
Item Number: ARN 3620
Manufacturer: Not mentioned
Product Type: Table Lamp
Power Source: Electrical outlet
Compatibility: Bulb not included
Usage: Indoor use only
Care Instructions: Clean only with a soft dry cloth or feather duster. Do not use abrasive or chemical agents.
Product Usage Instructions
- Tools Required (Not Included): Scissors
- Carefully remove all parts from the box. Place on a clean, soft surface.
- Remove socket ring (A) from socket (C).
- Remove shade (B) from packaging and install it to socket (C) using socket ring (A). If the shade has additional packaging, carefully cut it off from the interior of the shade to avoid damages.
- Install a light bulb into the socket.
- Remove the protective cover (D) from the plug.
- Plug the lamp into an electrical outlet.
- Test the fixture to ensure it is working properly.
Note: Before installation, make sure to inspect the item and its contents carefully. If any damage or defect is found, do not proceed with the installation. Retain all packaging material until installation is complete and approved.
Warning: This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with its construction and operation, as well as the hazards involved.
ASSEMBLY INSTRUCTIONS
Hunlen Table Lamp
Item # ARN 3620
NOTICE:
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction
and operation of it, as well as the hazards involved. Inspect item and
contents carefully. If any damage or defect is found, do not install.
Retain all packaging material until installation is complete and approved.
TOOLS REQUIRED (NOT INCLUDED):
Scissors
-
Carefully remove all parts from the box. Place on a clean, soft surface.
-
Remove socket ring (A) from socket (C).
-
Remove shade (B) from packaging and install to socket (C) using socket ring (A).
NOTE: If shade has additional packaging, carefully cut off from interior of shade to avoid damages. -
Install light bulb into the socket.
-
Remove protective cover (D) from plug.
-
Plug into electrical outlet and test the fixture.
Care Instructions: Clean only with a soft dry cloth or feather duster. Do not use abrasive or chemical agents.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>