HEARTH HOME technologies MOUNTAIN OAK-18 Vented Gas Log Set with Remote Control Kit Instructions

June 12, 2024
HEARTH HOME technologies

HEARTH HOME technologies MOUNTAIN OAK-18 Vented Gas Log Set with Remote

Control Kit

Log Placement Instructions

Models: MOUNTAIN OAK-18

WARNING!
The positioning of the logs is critical to the safe, clean operation of this gas log set. Sooting and other problems may result if the logs are not properly positioned per these instructions. Failure to position in accordance with the diagrams below, or failure to use only parts specifically approved for this log set may result in property damage or personal injury.

PLACE MOUNTAIN OAK-18 LOGS

  1. Place Rear Log (#1) on the rear support. Figure 1.
  2. Place Middle Log (#2) on middle support. Figure 2.
  3. Place Front Log (#3) in between the burner and grate. Figure 3.
  4. Rest Top Log (#4) in front and middle log cutouts. Figure 4.

NOTE: Logs #1, #2, and #3 have ridges on the bottom which secure the logs to the burner frame. After installing each log, check to be sure it is stable.

PLACE THE DECORATIVE ROCK

WARNING

  • DO NOT sprinkle volcanic rock on the logs or around the pilot or the main burner.
  • This may cause sooting. Only place a volcanic rock on the floor of the fireplace.
  • During the initial operation of the new heater, burning logs will give off a paper-burning smell and orange flames will be present.
  • Simply open the windows for a few hours to vent the odor.

Hearth & Home Technologies

  • 7571 215th Street West, Lakeville, MN 50044
  • www.hearthnhome.com.
  • Hearth & Home Technologies
  • Mountain Oak Installation Instructions
  • 4625-905 Rev. A

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

HEARTH HOME technologies User Manuals

Related Manuals