RobotDyn STM32F303CCT6 Black Pill Development Board Instructions

RobotDyn Black Pill STM32F303CCT6
Arduino IDE v2 Setup

STM32F303CCT6 Black Pill Development Board

Note: I use the traditional term “program”. “Sketch” sounds like something for children and idiots (IMO).

• Download and install the Arduino IDE v2.xx:

  • https://www.arduino.cc/en/software

• Download and install STM32CubeProgrammer:

  • https://www.st.com/en/development-tools/stm32cubeprog.html

• Run the Arduino IDE and add the following in File – Preferences – Additional boards manager URLs
  https://github.com/stm32duino/BoardManagerFiles/raw/main/package_stmicroelectronics_index.json Lots of updates and libraries will be downloaded.

• Under Tools

  • – Board, select “Generic STM32F3 series” .
  • – Board part number, select “RobotDyn BlackPill F303CC”. ·
  • – Upload method, select “STM32CubeProgrammer (DFU).

• Plug in the USB cable. The board should show in Device Manager, under USB Devices as “STM32 BOOTLOADER”.

• To upload your program to the board from the Arduino IDE, set the Boot jumpers as shown to use DFU bootloader mode.

• Upload your program as usual. After writing the Flash with your program, you should see the following (I know the button is labeled “upload”, but the text says “download”. I didn’t write it.):

• Your program is now running on the board. To upload your program to the board again, while still in the IDE, press the RESET button first, before uploading.

• To make the board run your program from Flash on power up, change the Boot 0 jumper to low (0). The Boot 1 jumper doesn’t matter.

References

• github.com/stm32duino/BoardManagerFiles/raw/main/package_stmicroelectronics_index.json
• Software | Arduino

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>