HEARTH HOME technologies ODLANAIG-48 Outdoor Linear Fireplace Instruction Manual
- June 12, 2024
- HEARTH HOME technologies
Table of Contents
- HEARTH HOME technologies ODLANAIG-48 Outdoor Linear Fireplace Instruction
- For Model:
- Overlay Kits
- A. Inner Overlay Kit Includes
- B Installation Instructions
- C. Outer Overlay Kit Includes
- D. Installation Instructions
- Read More About This Manual & Download PDF:
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
HEARTH HOME technologies ODLANAIG-48 Outdoor Linear Fireplace Instruction
Manual
For Model:
ODLANAIG-48, ODLANAIG60, ODLANAIG48-ST
Overlay Kits
Inner Overlay Kit (Reference A & B) – **SRV4111-025 (48in), SRV4112-025
(60in), SRV4113-025 (48inST)
Outer Overlay Kit (Reference C & D) – **SRV4111-173 (48in), SRV4112-173
(60in)
**** These kits have been tested for use with specific Hearth & Home Technologies products. Check with your local build- ing code agency before you begin installation to ensure compliance with local codes, including the need for permits and follow-up inspections. If you encounter any problems regarding code approvals, or if you need clarification of any of the instructions contained here, contact your Hearth & Home Technologies dealer. For the dealer nearest you, please visit www. hearthnhome.com.
CAUTION! Risk of Cuts, Abrasions or Flying Debris. Wear protective gloves and safety glasses during installation. Sheet metal edges are sharp.
A. Inner Overlay Kit Includes
- Left Overlay
- Right Overlay
- Rear Overlay
- Hardware Pack with drill bit
B Installation Instructions
-
Peel protective coating off of overlays and place rear overlay into back of firebox. No fasteners needed. The side overlay will hold rear panel in place. See Figure 1
Figure 1 Rear Overlay -
Place the right side overlay into the right side of the firebox. Align hole in top of firebox with tab on the top of the overlay. See Figure 2 and 3.
Figure 2 Right Overlay
- Right side panel will need to be put in place, then a hole will need to be drilled (with drill bit provided) into the firebox top through the overlay
- Attach with 2 screws provided. This will hold rear panel in place. See Figure 3 and 4
- Repeat Step 2 and 3 with left See Figure 4.
Figure 3 Screw Attachment
C. Outer Overlay Kit Includes
- Outer Overlay Piece
- Extended Hood
D. Installation Instructions
Note: If face is already covered by a facing material the overlay will need to be trimmed to fit.
- The overlay is the same outside dimension of the La- nai front. See Figure 5. Install overlay with a high temperature adhesive with a rating of 600° F or more on the inside of all See Figure 6.
- Remove existing hood and install extended
- Line up overlay with the outside dimensions of
- The inside dimension opening of overlay should line up with inside of appliance and hang on extended
After securing overlay to front and allowing to prop- erly dry and cure to adhesive manufacturer’s specs, peel off protective coating. Clean with a quality stain- less steel cleaner.
Figure 5 Overlay Installed
Figure 6 High Temperature Sealant ****
Hearth & Home Technologies
7571 215th Street West, Lakeville, MN 55044
www.hearthnhome.com
Hearth & Home Technologies • ODLANAI Overlay Installation Instructions •
4111-916 • Rev B • 08/22
Read More About This Manual & Download PDF:
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>