HEARTH HOME technologies DM6036 Bi-Fold Glass Doors Instruction Manual
- June 12, 2024
- HEARTH HOME technologies
Table of Contents
Installation
Instructions Models:
DM6036, DM6036-S
DM8042, DM8042-S
Glass Doors
DM6036 Bi-Fold Glass Doors
These bi-fold glass doors have been tested for use with specific Hearth & Home
Technologies products. Check with your local building code agency before you
begin installation to ensure compliance with local codes, including the need
for permits and follow-up inspections. If you encounter any problems regarding
code approvals, or if you need clarification of any of the instructions
contained here, contact your Hearth & Home Technologies dealer. For the dealer
nearest you, please visit www.hearthnhome.com.
Note: An arrow (→) found in the text signifies change in content.
CAUTION! Risk of Cuts/Abrasions. Wear protective gloves and safety
glasses during installation. Sheet metal edges are sharp.
WARNING
HOT SURFACES!
Screen/mesh, glass doors and other surfaces are hot during operation AND cool
down.”
Hot screen/mesh and glass doors will cause burns.
- Do not touch screen/mesh or glass doors until cooled
- NEVER allow children to touch screen/mesh or glass doors
- Keep children away
- CAREFULLY SUPERVISE children in same room as fireplace.
- Alert children and adults to hazards of high temperatures.
High temperatures may ignite clothing or other flammable materials.
- Keep clothing, furniture, draperies and other flammable materials away.
- Starting with the left side going in first, slip the bottom door track along the front edge of the hearth refractory and line it up end to end. See Figures 1-2.
- Install the top door track behind the front face. Secure the track in place with one screw from fastener pack, in the center.
- On each end of the top door track, add a spring clip to each end and secure with 2 screws each (they are also adjustment screws), also from fastener pack See Figure 3. If door pin doesn’t reach, it may be necesaary to adjust angle on spring clip by pulling down on clip after install.
• Install the Side Fillers
a. Push the screens to the center of the fireplace opening.
b. Slip the side filler in front of the side refractory with the notch to the
bottom and the tabs to the front. See Figure 4. c. Fasten the side filler to the corresponding holes in the
column with the screws provided in 2nd fastener pack.
Note: If there are no holes in the side column, use the side filler as a
template and drill holes in the column. Fasten filler to column. d.
Repeat for the other side.
Fold up one door (handles at the bottom) and set the bottom pin into the hole
in the bottom door track. See Figure 6. Slide the
top pins on the door into the top door track. Slide the door over until the
pivot pin snaps into the spring clip. See Figure 7. Repeat Steps 6-7 for the other side.
To adjust the door alignment, loosen the screws at the top spring clip,
sliding doors in or out, then tightening the screws.
Hearth & Home
Technologies
DM6036/DM8042 Glass Doors
33797 Rev I
Documents / Resources
|
HEARTH HOME technologies DM6036 Bi-Fold Glass
Doors
[pdf] Instruction Manual
DM6036, DM6036-S, DM8042, DM8042-S, DM6036 Bi-Fold Glass Doors, Bi-Fold Glass
Doors, Glass Doors, Doors
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>