sensolus TRACK 1000 Battery Powered Tracker User Manual

sensolus TRACK 1000 Battery Powered Tracker

Product Information: TRACK 1000 Battery Replacement

The TRACK 1000 is an asset tracker designed to send activity and GPS location information. It utilizes a battery for power and requires replacement when the battery runs out. Follow the instructions below for a successful battery replacement.

Product Usage Instructions: TRACK 1000 Battery Replacement

1. Step 1:

2. If using a power drill, set it to power seng 7 on low. Note that power drills may have different settings.

3. Make sure that the serial number and logo are facing the right way up.

4. Then turn the tracker face down.

5. Unscrew the 6 screws.
   Tip: I f using a power drill, use power seeing 7, on low.
   (Note: not all power drills have the same seeings!)

6. Step 2:

7. [No specific instructions provided]

8. Remove the back plate and the 6 screws.

9. Step 3: Place a finger on the sponge to hold it in place.

10. Remove the battries – pull them out of the connector.
    Tip : place a finger on the sponge to hold it in place

11. Step 4:

12. Position the chip so that the connector is towards the holder.

13. Place the chip so the connector is towards the holder.

14. Step 5:

15. Insert new batteries. Ensure that the batteries are positioned in the center, on top of the sponge, neither too low nor too high. Also, make sure the polarity (+/-) of the batteries is correct.

16. Insert new batteries. Position the new batteries and make sure the batteries are in the center (on top of the sponge) – not too low or too high.

17. Step 6:

18. Ensure that the connector is inside the holder and that the cable is tucked to the left-hand side.

19. Make sure the connector is inside the holder and that the cable is tucked to the left-hand side.

20. Step 7:

21. Ensure that the seal on the back of the tracker is completely intact.

22. Make sure that the seal is completelyfat/intact on the back of the tracker.

23. Step 8:

24. Close the case by tightening the 6 screws in the corresponding holes. Be cautious not to break the casing when using a power drill.

25. Step 9:

26. After closing the case, observe that the green light on the front of the tracker rapidly flashes green. This indicates that the tracker has started sending activity and GPS location information. To access this information, make sure you are in an area with Sigfox communication network coverage and visit the Sensolus Platform.

27. The green light on the front of the tracker will rapidly flash green. From this moment, your asset tracker will start sending activity (movement) and GPS location. This information will be visible in the Sensolus Platform if you find yourself in an area with Sigfox communication network coverage.

Indicate battery replaced in platform

When you replaced the battery in the tracker you have to indicate thet in the platform.

• Go to the tracker details page in the general section. You can search for this tracker or find in in the asset list or asset map.
• Go to the battery tab
• Click on the replace battery link to indicate you have replaced the battery of that tracker.
• Conferm the update.

Note: After replacing the battery in the tracker, it is important to indicate the battery replacement in the Sensolus Platform.

For more information or assistance, visit www.sensolus.com or contact info@sensolus.com.

References

• Sensolus, It Just Works! Industrial grade tracking solution.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>