sensolus TRACK 1100 Asset Tracking Solution Installation Guide
- June 5, 2024
- sensolus
Table of Contents
TRACK 1100 Asset Tracking Solution
Installation Guide
Install the tracker with bolts
- Use the appropriate size of screws, it is recommended to use the M6 type and to use thread locking glue on the bolts. We recommend Loctite Thread Locker Blue 242.
- Protect the tracker casing appropriately: protect the casing with a washer and use a spring washer to mitigate the effects of vibration and temperature variations.
- Don’t apply too much torque during the fixation: the maximum allowed torque is 3.5NM for an M6 screw used with a washer. Applying more torque may severely damage
the tracker’s casing.
Install the tracker with rivets
Use the appropriate size of rivets.
Choose the right length of the rivets.
The height of the casing where the mounting holes are located is 8mm.
We recommended using rivets with a diameter of 5mm.
Other installation methods
For alternative fixation methods such as magnets, glue, and double-sided tape
or tie-wrap please contact the Sensolus Help Desk.
support@sensolus.com or +32.9.298.09.43
Installation advice
Tracker activation
Activation of the trackers is preferably done with clear skies, and not inside
(e.g. factory or warehouse).
Trackers are not activated when delivered to your premises.
Their subscription to the platform will start within six months of purchase.
Troubleshooting
Force new configuration download on the tracker
Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to operate
this equipment.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
This equipment should be installed and operated with a minimum distance of
20cm between the radiator & your body.
www.sensolus.com | info@sensolus.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>