sensolus TRACK 1100 Battery Replacement Instruction Manual
- June 11, 2024
- sensolus
Table of Contents
TRACK 1100 Battery replacement manual
Instruction Manual
TRACK 1100 Battery Replacement
Step 1
• Make sure that the serial number and logo are facing the right way up.
• Then turn the tracker face down.
• Unscrew the 6 screws.
Tip: If using a power drill, use power setting 7, on low.
(Note: not all power drills have the same settings!)| Step 2
• Remove the back plate and the 6 screws.
---|---
|
Step 3
• Remove the battery and pcb pack as a whole| Step 4
Separate the battery pack from the PCB and line them up next to each other.
|
Step 5
Disconnect the battery pack from the PCB. Be carefull in disconnecting the
battery pack.| Step 6
Connect the new battery pack to the PCB, a green led will blink for a few
seconds.
|
Step 7
Align the battery on the back of the PCB.
Turn the wires around the PCB, there is a cutout in the PCB to guide the
wires.
The battery cannot cross the white lines on the PCB and cannot cover the radio
sensor.| Step 8
Place the battery and PCB pack back in the tracker.
There is a little cutout in the PCB to align properly in the tracker.
|
Step 9
Close the tracker carefully. Your tracker is ready to use
again.|
Indicate battery replaced in platform
When you replaced the battery in the tracker you have to indicate thet in the platform.
- Go to the tracker details page in the general section. You can search for this tracker or find in in the asset list or asset map.
- Click on the replace battery link to indicate you have replaced the battery of that tracker.
- Confirm the update.
www.sensolus.com | info@sensolus.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>