SUNRICHER 2303P Dali plus Push plus Phase LED Dimmer Instruction Manual
- June 12, 2024
- SUNRICHER
Table of Contents
DALI+ Push+ Phase Cut+0/1-10V LED Dimmer 
Important: Read All Instructions Prior to Installation
Function introduction
Product Data
Input Voltage| Output
Current| Output
Power| Remarks,| Dimming
Input| DALl
Consumption|| Dimming
Range| Ambient
Temperature
---|---|---|---|---|---|---|---
12-48VDC| 1x20A| 1x(240-960)W| Constant
voltage| DALIBAC Push&
4x28mm), DALISAC Pushe.| 2mA| 0.1%-100%| 20°C ~ +50°C
- Multifunction 4 in 1 LED Dimmer, with DALI, AC push, 0/1-10V and Phase Cut dimming interfaces
- In compliance with IEC 62386-101:2014, IEC 62386-102:2014, IEC 62386-207 Ed2.
- Built-in DALI-2 interface, DALI DT6 device
- Match all DALI systems in the market
- Dip switch to select different dimming interfaces
- 1 channel 12-48VDC output, max. 20A
- Supports both leading edge and trailing edge dimming input
- 1 DALI address assigned by DALI master
- Compatible with universal phase cut dimmers
- To work with power repeater to expand output power unlimitedly.
- Waterproof grade: IP20
Safety & Warnings
- DO NOT select dimming input with power applied to the device
- DO NOT install with power applied to device.
DO NOT expose the device to moisture.
Operation
DIP Switch to Select Dimming Input
Before wiring, please first select dimming input interface by DIP switch
depending on the control system used Different dimming interfaces can not be
wired and used simultaneously. Only 1 of the 4 can be selected and wired at a
time
DALI Address Assigned by DALI Masters
While select DALI dimming input, DALI address can be assigned by DALI Master
controller automatically, please refer to user manuals of compatible DALI
Masters for specific operations.
Wiring Diagram (When connecting with two separate loads and each one is
not over 10A)
Note: the device allows 0.5-2.5mm’ wire specifications, please make sure
the rated current of the used wire is enough for the loads.
-
With DALI Bus
-
With AC Push
Note: the Push Dim input voltage
range is 100-240VAC. -
With 0/1-10V
-
With Phase Cut Dim
Note: the Phase Cut Dim input
voltage range is 100-240VAC.
Wiring Diagram (When connecting with a single load that is over 10A)
Note: The used wire is enough for the loads. The device allows 0.5-2.5mm’
wire specifications, please make sure the rated current of the used wire is
enough for the loads.
-
With DALI Bus
-
With AC Push
Note: the Push Dim input
voltage range is 100-240VAC. -
With 0/1-10V
-
With Phase Cut Dim
Note: the Phase Cut Dim input
voltage range is 100-240VAC.
Product Dimension
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>