luminii LETO 11 and 11.5 Wet Canopy with Solid Stem Instruction Manual
- June 12, 2024
- luminii
Table of Contents
luminii LETO 11 and 11.5 Wet Canopy with Solid Stem
Product Information
LETO 11 & 11.5 Wet Canopy with Solid Stem
The LETO 11 & 11.5 Wet Canopy with Solid Stem is a product designed for installation and maintenance purposes. It is important to read and follow the instructions provided in this manual before installing or maintaining the product. The product is made in Canada and comes with a warranty.
For any warranty claims, it is essential to avoid unauthorized modifications and improper use of the product.
Contact Information:
- Phone: 403-216-7043
- Email: info@sensolighting.com
Product Usage Instructions
Installation
- Attach the bracket to the junction box, ensuring that the wiring remains accessible.
- If you have two stems, apply loctite to the threads. Feed the wires through one stem and screw both stems together.
- Pass the wire through the washer and canopy. Make electrical connections.
- Slide the canopy past the stem and hold it against the ceiling.
- Apply loctite to the threads. Push the feed cable into the canopy and thread the stem.
- Before finishing the installation, apply silicone around the edge for sealing purposes.
Please note that these instructions are provided as a general guide and may
vary depending on specific installation requirements.
If you encounter any difficulties or have any questions, it is recommended to
seek assistance from a licensed electrician or contact the manufacturer using
the provided contact information.
Overview
Read and follow these instructions before installing or maintaining this product
This product is suitable for DAMP OR WET LOCATIONS
- Make sure this product is NOT on the same circuit as inductive loads, (e.g. fluorescent bulbs, discharge bulbs, ventilation fans, etc…)
- Allow air to flow freely around the fixture
- Do not switch on line voltage until all wiring is complete
- Incorrect wiring will result in irreparable damage to LED and power supply
- This product should only be installed by a licensed electrician
Warranty
- This product must be installed in accordance with all applicable installation codes and ordinance
- Limited five (5) years warranty
- Warranty is void in the eventuality of unauthorized modifications and/or improper use
Installation
- Attach bracket to junction box. Leave wiring accessible.
- If you only have one stem, skip to step 3. Add loctite to threads. Feed the wires through the other stem and screw each stem together.
- Pass wire through washer and canopy. Make electrical connections.
- Slide canopy past stem and hold against ceiling.
- Add loctite to threads. Push feed cable into canopy and thread stem.
- Apply silicone around edge before finishing install.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>