Luminii DW68 Series LineLED Warm Dim LED Strip Instruction Manual

: June 12, 2024
: luminii

Luminii DW68 Series LineLED Warm Dim LED Strip

Luminii-DW68-Series-LineLED-Warm-Dim-LED-Strip-Product-
image

LineLED DW68 Series

IP65, IP67, & IP68 rated Linear LED strip – 24VDC

Features

Dynamic White

Technical Information

Mounting: LED strip is equipped with 3M™ self-adhesive
tape.
Operating voltage: 24 VDC
Average Life (L70): 50,000 hours
Warranty: 3 years

Applications

Outdoor and wet locations – cove lighting, architectural accent, handrail, wet bars.

Approvals

IP65, IP67, and IP68 Rated

Output Options

TYPE| Lumens Output (all channels full on)| Average Power Consumption (for a 4′ section)| Efficacy| Cutting Increment (in)| Max Run Length (in series)| Dimensions
---|---|---|---|---|---|---
LLDW68WET-T| 299 lm/ft (29K)| 4.6 W/ft| 65 lm/W| 2.46| 32 ft| 0.53W x 0.24 H
LLDW68WET-T| 380 lm/ft (44K)| 5.6 W/ft| 75 lm/W| 2.46| 32 ft| 0.53W x 0.24 H
LLDW68WET-T| 456 lm/ft (44K)| 4.6 W/ft| 63 lm/W| 2.46| 32 ft| 0.53W x 0.24 H
LLDW68WET-T| 352 lm/ft (29K)| 5.6 W/ft| 74 lm/W| 2.46| 32 ft| 0.53W x 0.24 H

Ordering Code

MODEL: LLDW68WET-T
OUTPUT: SO (19K-35K), SO (27K-65K), HO (19K-35K), HO
(27K-65K)
CCT: 1900K, 2700K, 2900K, 3500K, 4400K, 6500K
SELECTION START1: SL65, SL68, LF, LM, NC
SELECTION END1: SL65, SL68, LF, LM, NC
LENGTH: Ordered in one foot increments. See chart above for max run
length.

Accessories

LVSP-WET: Splice box – wet rated, low voltage, gray
LVSP-WET-CM: Splice box connector – low voltage, gray
CL2: Mounting clip
LL.ZIP: Cable/Wire Strain Relief Clip (zip tie included)

Lens Options / Light Transmission

| C| HF| G| F| FF| R| S| Q
---|---|---|---|---|---|---|---|---
CLA Channel (CLAC-XX)| 0.84| 0.64| 0.77| | | | |
KL Channel (KLC-XX)| 0.30| 0.70| 0.83| | | | |
KRL Channel (KRLC-XX)| 1.21| 0.42| 0.70| 0.83| | | |
KXL Channel (KXLC-XX)| 0.50| 0.70| 0.83| | | | |
KRXL Channel (KRXLC-XX)| 1.21| 0.63| 0.70| 0.83| | | |
RO15 Channel (RO15-XX)| 0.71| 0.55| 1.40| | | | |

Installation

All mounting channels are field cuttable using miter saw with circular blade suitable for cutting aluminum.

Ordering
Please refer to the ordering code and select the appropriate options based on your requirements.

LineLED DW68 Series

IP65, IP67, & IP68 rated Linear LED strip – 24VDC

Features

Line LED Dynamic White Series Wet is a small profile high performance LED strip for IP65, IP67, and IP68 wet rated installations. This Dynamic White LED series offers a wide CCT range to create the perfect ambiance in real time. From bright white encouraging wakefulness, to warm amber sunsetting into relaxation, Line LED DW68 can transform any environment to match the natural human circadian rhythm. Industry-best color consistency with single-binned LEDs, 120 LEDs per foot. This High Color Quality LED strip boasts CRIs and R9 values up to 97. It is easily installed within discrete aluminum extrusions with multiple mounting options.

Mounting
LED strip is equipped with 3MTM self-adhesive tape.

Applications
Outdoor and wet locations – cove lighting, architectural accent, handrail, wet bars.

Approvals
IP65, IP67 and IP68 Rated.

Operating voltage 24 VDC
Average Life (L70) 50,000 hours

Warranty
3 years

Technical information

Luminii-DW68-Series-LineLED-Warm-Dim-LED-Strip-04

Section Start/End Options

Luminii-DW68-Series-LineLED-Warm-Dim-LED-Strip-06

Ordering Code

Luminii-DW68-Series-LineLED-Warm-Dim-LED-Strip-07

IP rating of strip is equal to the lowest IP rating of section start and end options.

Accessories

Luminii-DW68-Series-LineLED-Warm-Dim-LED-Strip-07

Recommended every 12” when Line LED strip is facing down. Luminii-DW68
-Series-LineLED-Warm-Dim-LED-Strip-09

Lens Options / Light Transmission

using the frosted lens option

Installation

All mounting channels are field cuttable using miter saw with circular blade suitable for cutting aluminum.

Ordering

Extrusions are sold separately. View respective specsheets for details on ordering extrusions and their accessories (endcaps, mounting brackets, etc).

Power Consumption

Tested at full power with PDC Series power supplies.

Nominal Length| W/ft| Total Wattage| W/ft| Total Wattage
---|---|---|---|---
1| 4.6| 4.6| 5.9| 5.9
2| 4.7| 9.8| 5.9| 12.3
3| 4.7| 14.5| 5.9| 18.3
4| 4.7| 19.0| 5.9| 24.0
5| 4.6| 22.5| 5.8| 28.6
6| 4.7| 27.6| 5.6| 33.1
7| 4.4| 30.5| 5.5| 38.5
8| 4.5| 35.8| 5.5| 44.2
9| 4.4| 39.7| 5.3| 47.8
10| 4.2| 42.7| 5.2| 52.5
11| 4.2| 46.5| 5.0| 55.7
12| 4.0| 48.5| 4.9| 59.6
13| 4.0| 51.1| 4.8| 61.3
14| 4.0| 55.4| 4.6| 64.0
15| 4.0| 59.4| 4.5| 67.8
16| 3.8| 61.4| 4.4| 70.4
17| 3.7| 63.5| 4.3| 72.6
18| 3.6| 65.6| 4.1| 73.5
19| 3.5| 67.6| 3.9| 73.7
20| 3.5| 69.6| 3.7| 74.7
21| 3.4| 71.2| 3.6| 75.5
22| 3.3| 72.4| 3.5| 76.5
23| 3.2| 73.7| 3.4| 77.5
24| 3.1| 74.8| 3.3| 78.5
25| 3.1| 77.2| 3.2| 79.9
26| 3.0| 78.0| 3.1| 80.7
27| 2.9| 78.9| 3.0| 81.6
28| 2.8| 79.8| 3.0| 82.8
29| 2.8| 81.0| 2.9| 82.9
30| 2.7| 81.3| 2.8| 83.5
31| 2.7| 82.2| 2.7| 84.2
32| 2.6| 82.6| 2.7| 84.8

The below chart assumes nominal voltage of 24 Volts and a Voltage Drop Allowance of 3% through the wire.

Wattage	Maximum Wire Length From Power Supply to Start of Run
12 AWG	14 AWG
5	1088.2
10	544.1
15	362.7
20	272.0
25	217.6
30	181.4
35	155.5
40	136.0
45	120.9
50	108.8
55	98.9
60	90.7
65	83.7
70	77.7
75	72.5
80	68.0
85	64.0
90	60.5
96	56.7

Power Supplies

See fixture and power supply instructions & spec sheet for wiring information. Dimming possible in select models – view Luminii website for list of compatible dimmers.

Luminii-DW68-Series-LineLED-Warm-Dim-LED-Strip-10

Non-Dimming Power Supply 120VAC – 277VAC

Luminii-DW68-Series-LineLED-Warm-Dim-LED-Strip-12

Non-Dimming Power Supply 120VAC – 277VAC Luminii-DW68-Series-LineLED-
Warm-Dim-LED-Strip-12

Decoders

DMX512 decoder with RDM functionality features 5 PWM output channels with common anode. High PWM output frequency range allows the product to be used in HD video conferencing spaces. All DMX products to be installed per DMX512 Standard.

Power
96 Watt
Inputs
RJ45, XLR-5Pin, Terminal Block
DMX Channels
1 to 5 settable
PWM Output Resolution Ratio
8 or 16 bit
PWM Output Frequency
500Hz – 30KHz
Output Dimming Curve Gamma Value
0.1 ~ 9.9

Translates controller DMX512 programs for RGB and white LED strips. Unique DMX address for the decoder can be set easily and displayed by the numeric display on the case. Changing and resetting the DMX address requires manual input. Use power repeater to expand output (Luminii part# RGBW-SR).

Operating Voltage
12-36 VDC
Power Capacity
up to 96W at 24V
Operating Temperature Range
from -4˚F to +122˚F in case
PWM Output Frequency
200Hz or 1500Hz

Dynamic white wall-mount controller controls lighting fixtures, wireless control of DW lighting fixture. Fits in any standard US switch box. Includes all the outputs in the back of the controller.

Features

Switch & dimming control function, control range > 20M.
Smooth transition between light levels.
Separately operate dimming and color temperature functions.
Able to control 1 zone with endless receivers. Each receiver can maximally be controlled by 8 remotes.
Power, temperature color and dimming functions operated by push button after receivers are connected.

Operating Voltage
3V DC battery
Color Parameters

Brightness
Saturation
Fading

Decoders

Dynamic white DMX wall-mount controller is a fully touch sensitive controller designed in accordance with standard protocol DMX512. Offers fast and accurate color temperature adjustment and brightness dimming of natural white, warm white and cold white. Designed with a touch color wheel, the DMX512 controller can adjust color temperature and brightness for all white LEDs smoothly and accurately. The DMX controller can control 1 zone with endless decoders.

Features

1 zone
6 color scenes
DMX Control
Touch Sensitive Glass Surface
Dimming and Speed Control
Memory Function
Easily Fits Standard US Switch Boxes

Operating Voltage
12 – 24V DC
Color Parameters

Brightness
Saturation
Primary colors
Fading
Color changing speed

The RGBW receiver is easily paired with controller by the click of a button. Receiver can be reset to factory settings at any time. Each receiver can store one static RGB color, one color sequence, and one brightness setting for the white LED strip. Receivers assigned to the same scene within the same zone will have the same LED static color and color sequence.

Operating Voltage
12-36 VDC
Power Capacity
up to 96W at 24V
Operating Temperature Range
from -4˚F to +122˚F in case

Extends identical signal when connected in series to an RGBW LED control system. The RGBW signal repeater works with Luminii RGB and RGBW controllers, receivers, and decoders. RGBW signal can be extended indefinitely when adequate power supply (not included) is connected to the system.

Operating Voltage
12-36 VDC
Power Capacity
up to 96W at 24V
Operating Temperature Range
from -4˚F to +122˚F in case

The SLD DimTW is a constant voltage warm dimming LED dimming module. The unique dimming module accepts 0-10V control and mimics a smooth, incandescent dimming curve.

Features

Flicker free 0-100% dimming
High efficiency up to 97%
High precision dimming ratio:>1:1000
Fully isolated plastic housing
Comply with EN55015 and FCC part 15 without additional input filter and capacitors
compact size, high reliability
3 years warranty

Programmable advanced DMX512 lighting controller featuring a touch-screen interface. Operates as stand alone controller or integrated with most architectural lighting control systems. Can controller endless DMX512 enabled devices. Mounts to standard single or dual gang wall box with the included power supply inside the junction box. Terminal block design for power and data connections.

Features