luminii MP-DO-DW-22K-60K Matrix Plus Dynamic White LED Panel Instruction Manual
- June 12, 2024
- luminii
Table of Contents
luminii MP-DO-DW-22K-60K Matrix Plus Dynamic White LED Panel
Important Information
Please read complete instruction prior to installation and keep for future reference!
- PRODUCT TO BE INSTALLED BY A QUALIFIED ELECTRICIAN.
- PRIOR TO INSTALLATION ENSURE POWER IS OFF AT FUSE BOX TO PREVENT ELECTRICAL SHOCK.
- ACCESS IS REQUIRED FOR SERVICE AND MAINTENANCE
Installation Instructions
Note: Matrix can be cut along the dashed lines to configure into varies configurations. Reference step 2 for additional information.
1.1 Clean the area thoroughly from any dust and or adhesive residue where
the Matrix will be installed. Reference the sample layout on page 3 for
additional information.
1.2 Remove the paper backing from the Matrix. Carefully stick onto
thesurface firmly. Make sure there are no air bubbles or ripples that can
cause irregularities and affect from sticking on correctly. If adhesive not
sticking well to the surface. Reference step 4 to use mounting hardware (not
included).
Note: When removing the backing & placing the Matrix to the surface,
avoid any ripples. As shown in FIG.1.
Note: Matrix Plus & Matrix Mini Plus can be installed in multiple
configuration. 1 male adapter must be connected from 1 section to the next to
work properly.
Note: While Matrix Plus & Matrix Mini Plus can be installed in multiple
configurations, make sure to keep polarity consistency. Warm White (WW) needs
to connect to Warm White (WW) and Cool White (CW) needs to connect to Cool
White (CW). The easiest way to make sure the polarity is consistent is to
align the matrix pieces with the Luminii logo in the same orientation.
Connect the power feed wire into the one of the female/male connectors that is soldered on the Matrix. By sliding and then pushing completing into the connector. Secure by placing clip (CL -1) over the connector and secure using the two screws. Reference diagram below for more details.
OPTIONAL: There are 2 additional mounting options, when the adhesive tape
is not sticking on to the surface properly. The first and easier solution is
to use push-pins. Only can be used in the areas on the board outlined with a
push-pin illustration. The second is to use #0 screw size with an electrical
insulating polypropylene plastic washer 0.065’’ID, 0.188’’ OD. Insert the
screw/washer through the Matrix Plus mounting holes to secure Matrix properly
to surface.
SAMPLE LAYOUT: Refer to specifications below when installing the Matrix into an enclosed area.
- enclosure must have minimum of 1” depth, from where the matrix is installed.
- 3/4” holes must be made every 8” on the sides of surface.
Multiple powerfeed variation:
Wiring Diagrams
Operations to controller Controller
- Press the learning key on the receiver, then push the rotary button. Once successfully learn, the LED lights will blink on the receiver. Do the same for the other receivers if you use them, you can add as many optional receivers as you want
- Short press once the rotary button to switch on/off. Adjust dim brightness by the rotary button from left to right 0.1 – 100%. Adjust dim brightness by the rotary button from right to left 0.1 – 100%. Long press rotary button, the light will be 100% brightness
Double click rotary button, it will enter into dimming color temperature mode,
dim WW & CW associatively, for example if WW is 70%, CW is 30%. Double click
again, will enter into dimming brightness mode.
CUSTOMER SUPPORT
7777 N. Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
info@luminii.com
www.luminii.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>