EVOLUTION POWER SPORTS Sand 40-45 2022 Can Am X3 Shift-Tek-P Essential Clutch Kits Instruction Manual
- June 12, 2024
- EVOLUTION POWER SPORTS
Table of Contents
EVOLUTION POWER SPORTS Sand 40-45 2022 Can Am X3 Shift-Tek-P Essential
Clutch Kits Instruction Manual
INCLUDED PARTS
- Helix Assembly
- No Mar Tip
- Belt Sheave Tool
REQUIRED TOOLS
- Clutch Service Tool Kit
- Screwdriver(s)
- 13,17,19,22mm Sockets
- Impact Driver
- 6mm Allen Socket
- Red Loctite
- Torque Wrench
BILLET HELIX PACKACE
INSTALLATIONS INSTRUCTION
Step 1: Remove CVT outer clutch cover and belt.
Step 2: Remove the secondary clutch with a 17mm socket and impact, mount
it into a clutch compression tool. With a sharpie make alignment marks on both
sheaves. (Figure 1)
Step 3: Use 13mm socket to take 3 fasteners out of the helix and carefully loosen the spring compression tool to remove tension. (Figure 2)
Step 4: Pull off both sheaves, remove spring cup and spring from the OEM
helix.
Step 5: Grab the new helix, make sure the helix cap is adjusted to -45
degrees, if not loosen (3) Allen screws and clock the helix cap. Tighten the
(3) Allen screws back down.
Step 6: Reassemble the secondary clutch on the clutch compression tool in this order: Helix assembly, stock spring in hole 4 (EVP Purple Spring hole 5), spring cap, both sheaves in alignment. When compressing make sure the rollers are in line with the helix ramps. You may need to adjust with your hands while compressing.
Step 7: Apply Red Loctite onto the threads of the (3) 13mm bolts holding the helix to the sheaves.
Step 6: Reinstall the clutch on the vehicle and torque secondary bolt to 52 ft-lbs.
Step 7: Using the Can Am belt changing tool with EVP non-marring tip reinstall belt, spin secondary to get belt back to the top of the clutch
Step 8 : Before removing the belt changing tool, apply a small amount of pressure to EVP helix cover and loosen the (3) 6mm Allen screws enough to clear the machined grove
Step 9: Put the EVP sheave holder between the fins on the secondary clutch and use a screwdriver to rotate the helix cover clockwise to desired tension. Use the 6mm Allen to tighten the screws back down. (See picture on next page)
Thank you for choosing Evolution Powersports products. If you require further assistance, please call our Tech Support @ (715) 247-386
Note: This product is exempt from the emission standards and related requirements of 40 C.F.R. § 1051 as provided by 40 C.F.R. § 1051.620, and California law [e.g., vehicle code§§ 27156 and 38391]. This product is sold only for use in connection with EPA certified, purpose-built, nonroad vehicles used solely for closed course, nonroad competition/racing and not used for any recreational purpose or on public highways or right of ways maintained by and open to the public. This product is sold only in connection with machines that do not fall under state and/or federal noise or emission standards/regulations. Purchasers who/that purchase this product represent and warrant that the product is purchased only in connection with EPA -certified, emission-regulations-exempt and noiseregulations-exempt competition/racing vehicles as interpreted under applicable state and/or federal law. Questions: Call Evolution Powersports at 715-247-3862.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>