MINKA LAVERY 3859-756 15 Inch 4-Light Antique Nickel Semi Flush Mount Installation Guide
- October 30, 2023
- MINKA LAVERY
Table of Contents
MINKA LAVERY 3859-756 15 Inch 4-Light Antique Nickel Semi Flush Mount
Installation Guide
PREPARING FOR INSTALLATION
-
Shut off power at the fuse box or circuit breaker box and remove the old fixture including the mounting hardware.
-
Carefully unpack your new fixture and lay out all the parts in a clean area. Take care not to misplace any small parts necessary for installation.
ASSEMBLING THE FIXTURE (Fig.1)
-
Thread rod and canopy assembly (E) onto all thread (F) on top of fixture body.
-
Attach mounting plate (A) to junction box (not included) with mounting screws (B) (Size: #8-32N*L0.5”). The side of the mounting plate marked “GND” and two convex points must face out.
CONNECTING THE WIRES (Fig. 2)
-
Connect the electrical wires as shown in fig.2, making sure that all wire connectors are secured. If your junction box has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the mounting plate (A) using the green screw provided.
-
Tuck wire connectors neatly into the junction box and raise the canopy (D) to ceiling.
COMPLETING THE INSTALLATION (Fig. 1) -
Place canopy (D) over mounting plate (A) and secure with screws (C).
-
Place candle covers (H) over sockets (I).
-
Install (4) four candelabra base bulbs (G) up to 60 watts each or CFL or LED equivalent (not included) in accordance with the fixture specification. —DO NOT EXCEED THE MAXIMUM WATTAGE RATING! (NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE!)
Your installation is now complete. Return power to the junction box and test the fixture.
Note: Illustration (Fig. 1) on this manual is for installation purposes only. It may or may not be identical to the fixture purchased.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>