FORCE1 Zero G Climber RC Car Instruction Manual

: June 3, 2024
: FORCE1

Table of Contents

DRIVING ON THE GROND
Controller
BATTERY INSTALLATION
LED LIGHTS
CHARGING INSTRUCTION
TROUBLESHOOTING
Documents / Resources
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)

FORCE1 Zero G Climber RC Car Instruction Manual

DRIVING ON THE GROND

Switch the climb to FLOOR mode.

**Wall/Floor/Off

**

Switch the climber to WALL mode.

The fabric strips can be adjusted upward at a 45° angle to ensure
the car sticks properly to the wall.

Place the vehicle on the wall as shown.

Controller

If the car is not driving straight, try adjusting the trim either left or right by pushing and holding the trim button. If the car drifts to the right, use the left trim button. If the car drifts to the left, use the right trim button.
Controller

BATTERY INSTALLATION

Loosen the screw and remove the battery compartment door.
Install 3 x AAA batteries (not included) in the battery compartment as shown.
Make sure to follow the correct positive and negative polarities with the corresponding markings inside the battery compartment.
Re-Install the battery compartment door and tighten the screw.

Push the left joystick up or down to make the climber go forward or reverse.

Push the right joystick to the left or right to star 60 spins!
Controller

LED LIGHTS

Controller

CHARGING INSTRUCTION

Make sure the vehicles WALL / FLOOR / OFF switch is in the OFF position.
The car can only be charged when the vehicle Is on the OPP position.
Plug the charging cable into the port in the back of the vehicle.

While charging, a red Eight will illuminate he USB charger. When hanging is complete , he red light will turn off.

Charge Time: Approximately 60 minutes
Play Time: Approximately It minutes in wall mode
Approximately EO minutes in floor mode

WARNING: Do not charge the battery immediately after use Let the battery cool down for at least IO minutes.

TROUBLESHOOTING

P ROBLEM| SOLUTION
Vehicle will not start|

Make sure the climber is fully charged and transmitter has new AAA batteries Installed in the correct polarity.
Make sure the climber switch on the back of the car is turned to either wall or floor.

Vehicle does not climb|

Make sure the climber is fully charged and transmitter has new AAA batteries installed in the correct polarity.
Make Sure the climber switch on the back of the car is switched to “wall”
Make sure the driving surface is smooth.

Vehicle does not drive straight|

Make sure the surface is clean of dirt/dust
Coke sure the su4oce is smooth.
Adjust the trim using the buttons on the transmitter.
See instruction in the manual

Vehicle slips climbing the walls|

Make sure the climber is fully charged.
Fold up the fabric skirts for a better seal prior to use
Make sure the surface is smooth

|

Make sure to drain the battery, then charge it again for 1 hour.
Clean tires and make sure your wall and floor are Also clean
Check the fabric skirts for damage. If hey have been pulled loose, tape them back with flexible tape.
Make sure surface is flat.
Suction is jammed, clear the suction fan on the bottom of the car of any debris.

ALWAYS USE UNDER ADULT SUPERVISION

NOTE: USE ON SMOOTH, CLEAN SURFACES ONLYI

LEARN MORE ABOUT FORCE1 Www.forcelrc.com

Scan Me