Minka Lavery 4045-84 Acacia 4 Light Brushed Nickel Candlestick Chandelier Installation Guide
- October 30, 2023
- MINKA LAVERY
Table of Contents
INSTALLATION INSTRUCTIONS
Item#4045-84 (New. 07/05/2021)
READ AND SAVE THESE INSTRUCTIONS
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
MOUNTING THE FIXTURE (Fig.1)
1. Shut off power at the fuse box or circuit breaker and remove the old
fixture included the mounting hardware.
2. Carefully unpack your new fixture and lay out all the parts on a clean
area. Take care not to lose any small parts necessary for installation.
3. Adjust position of each lamp arm. (As shown in Fig.2)
4. Place mounting plate (B) over outlet box (A) (Not included) and align
mounting slots with mounting holes of outlet box (A). Feed mounting screws (C)
through mounting slots of mounting plate (B) and mounting holes of the outlet
box (A). Make sure the side of the mounting plate (B) marked “GND” must face
out.
5. Determine desired hanging height and thread rods (I1 and I2) to the all
thread of the fixture body. Screw loop (H1) onto rod (I1). Pass the wires
carefully through each rod as you assemble.
6. Attach quick link (G) to loop (H1) and loop (H2) on canopy (E). Carefully
feed wire through loop (H1), quick link (G), and loop (H2).
CONNECTING THE WIRES (Fig.3)
7. Connect the electrical wires as shown in Fig.3, making sure that all wire
connectors (D) are secured. If your outlet box has a ground wire (green or
bare copper), connect the fixture’s ground wire to it. Otherwise, connect the
fixture’s ground wire directly to the mounting plate (B) using the green screw
provided.
8. Tuck wire connections neatly inside the outlet box (A).
FINISHING THE INSTALLATION (Fig.1)
9. Thread fixture screws (F) through canopy (E) and into mounting plate (B)
and secure.
10. Place glass shade (K) over socket cups (J). Secure glass shade (K) using
metal rings (L). Install (4) four medium base (E26) bulbs (M) up to 60 watts
each or CFL or LED equivalent (not included) in accordance with the fixture
specification– DO NOT EXCEED THE MAXIMUM WATTAGE RATING! (NE PAS
DEPASSER LA PUISSANCE NOMINALE MAXIMALE!).
Fig.1
Set# A-016
-Mounting Plate
-Ground Screw
-Mounting Screw*2
Your installation is now complete. Return power and test the fixture.
Note: Illustration (Fig.1) on this manual is for installation purposes only. It may or may not be identical to the fixture purchased.
Fig.3
- FIXTURE WIRES Black or Smooth
- HOUSE WIRES Black (Hot)
- FIXTURE WIRES White or Ribbed
- HOUSE WIRES White (Neutral)
- FIXTURE WIRES Green or Bare Copper (Ground)
- HOUSE WIRES Green (Ground)
4045-8
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>