VISUAL COMFORT 4455702-112 CodynWall 1.0 1-Light Satin Brass Wall Sconce Instruction Manual
- October 30, 2023
- VISUAL COMFORT
Table of Contents
VISUAL COMFORT 4455702-112 CodynWall 1.0 1-Light Satin Brass Wall Sconce
- Product Name: CODYN_WALL
- Model Number: 4155701, 445570_ 1.0
- Product Type: Wall fixture
CAUTION – RISK OF FIRE: This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. Please save these instructions for future reference.
Product Installation Steps
- Secure the mounting plate (4) to the junction box (1) using screws or other appropriate hardware.
- Place the shade (6) onto the socket (7) and secure it in place by screwing the shade collar nut (2) onto the socket. Do not overtighten.
- Install the cap nuts (3) onto the studs.
Please note that this instruction shows a typical installation. Your specific installation may vary based on your junction box and mounting requirements.
GENERAL PRODUCT INFORMATION
- These fixtures are intended to be installed utilizing NEC compliant junction boxes.
- This product is safety listed for damp locations.
- Incandescent version may be dimmed with a standard incandescent dimmer.
- LED version may be dimmed with a LED dimmer. Consult lamp manufacturer for additional information.
- This instruction shows a typical installation.
CAUTION: RISK OF FIRE
This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. Use minimum 90°c supply conductors.
SAVE THESE INSTRUCTIONS
Install the Fixture
- Secure the mounting plate to the junction box.
- Place the shade on to the socket and secure it in place by screwing the shade collar nut onto the socket. Do not over tighten. If necessary, repeat for all the other shades.
- Screw the lamp(s) into the socket(s). Refer to the label on the socket for Max Wattage Information.
- Connect the fixture to a suitable ground in accordance with local electrical codes.
- Connect the white fixture wire to the neutral power line wire with a wire nut.
- Connect the black fixture wire to the hot power line wire with a wire nut.
- Neatly place the wires into the junction box, place the fixture onto the mounting studs, and secure it in place by screwing the cap nuts onto the studs.
Contact
GENERATION LIGHTING
- 7400 Linder Ave., Skokie, IL 60077
- T: 847.410.4400
- F: 847.410.4500
- www.generationlighting.com
©2022 Visual Comfort & Co., L.L.C. All rights reserved. The Visual Comfort & Co. logo is a registered trademark of Visual Comfort & Co. Visual Comfort & Co. reserves the right to change specifications for product improvements without notification.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>