MINKA LAVERY 2892-691 Pullman Junction 13 Inch 2-Light Brushed Nickel and Coal Vanity Light Instruction Manual
- October 30, 2023
- MINKA LAVERY
Table of Contents
MINKA LAVERY 2892-691 Pullman Junction 13 Inch 2-Light Brushed Nickel and
Coal Vanity Light
Product Information
The product is an electrical fixture with item numbers 2892-691. The product was manufactured on August 18th, 2021. The user manual includes instructions on how to install the fixture and provides a warning to shut off power at the fuse box or circuit breaker before installation.
Product Usage Instructions
- Shut off power at the fuse box or circuit breaker box.
- Remove the old fixture, including the mounting hardware.
- Unpack the new fixture carefully and lay out all the parts.
- Mount the fixture using the provided mounting plate and screws (Set#A-021-300117).
- Connect the fixture wires to the house wires as follows:
- Black or smooth fixture wire to black/hot house wire.
- White or ribbed fixture wire to white/neutral house wire.
- Green or bare copper fixture wire to green/ground house wire.
- Your installation is now complete. Return power and test the fixture.
Note: The illustration in Fig.1 is for installation purposes only and may or may not be identical to the fixture purchased.
INSTALLATION INSTRUCTIONS
- Item#2892-691 (New. 2021/8/18)
READ AND SAVE THESE INSTRUCTIONS
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER. AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
MOUNTING THE FIXTURE
- Set#A-021-300117
- Mounting Screw*2
- Ground Screw
- Mounting Plate
- Shut off power at the fuse box or circuit breaker box and remove the old fixture including the mounting hardware.
- Carefully unpack your new fixture and lay out all the parts in a clear area. Take care not to misplace any small parts necessary for installation.
- Loosen screws (E) to remove mounting plate (A) from fixture body (F).
- Position mounting plate (A) on the wall, and mark the location of two drywall anchors (B). Pre-drill the holes for the drywall anchors (B). Insert the drywall anchors (B) into the wall.
- Attach the mounting plate (A) to the junction box (not included) using the mounting screws (D). The side of the mounting plate (A) marked “GND” must face out.
- Screw woodscrews (C) through the holes into the drywall anchor (B) to secure the mounting plate (A) as shown in Fig.1.
CONNECTING THE WIRES
- Connect the electrical wires as shown in Fig. 2, making sure that all wire connectors are secured. If your junction box has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the mounting plate (A) using the green screw provided. After the wires are connected, tuck them carefully inside the junction box.
FINISHING THE INSTALLATION
- Slide fixture body (F) over the mounting plate (A) and secure with screws (E).
- Install (2) two candelabra base bulbs (H) up to 60 watts each or CFL or LED equivalent (not included) in accordance with the fixture specification. —DO NOT EXCEED THE MAXIMUM WATTAGE RATING! (NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE!)
- Screw glass shades (I) onto socket cups (G). Your installation is now complete. Return power and test the fixture.
Note: The illustration (Fig.1) in this manual is for installation purposes only. It may or may not be identical to the fixture purchased.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>