VISUAL COMFORT TOB2722 Turlington Large Sconce Instruction Manual
- October 30, 2023
- VISUAL COMFORT
Table of Contents
VISUAL COMFORT TOB2722 Turlington Large Sconce
Product Information
The Turlington Large Sconce is a light fixture that requires assembly and installation. It comes with a mounting plate (A), screws (B and D), and a ground wire (bare copper). The product does not include a bulb. It is important to follow all applicable local installation codes and have a person familiar with the construction and operation of it install the fixture. The product should be inspected for damage or defects before installation and all packaging material should be retained until installation is complete and approved.
Product Usage Instructions
- Carefully remove all parts from the box and place them on a clean, soft surface.
- Remove the mounting plate (A) from the fixture by removing screws (D).
- Install the mounting plate (A) to the junction box and secure it with the mounting screws (B).
- Wrap the fixture ground wire (bare copper) around the green grounding screw on the mounting plate and tighten the screw.
- Attach the fixture to the mounting plate using screws (D).
- Install a bulb (not included) according to its instructions.
- Clean the fixture only with a soft dry cloth or feather duster. Do not use abrasive or chemical agents.
NOTICE
This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with the construction and operation of it, as well as the hazards involved. Inspect item and contents carefully. If any damage or defect is found, do not install. Retain all packaging material until installation is complete and approved.
TOOLS REQUIRED
(NOT INCLUDED)
Phillips Screwdriver
Slotted Screwdriver
ASSEMBLY INSTRUCTIONS
- Carefully remove all parts from the box. Place on a clean, soft surface.
- Remove mounting plate (A) from fixture by removing screws (D).
- Install mounting plate (A) to the junction box and secure with the mounting screws (B).
- Wrap fixture ground wire (bare copper) around the green grounding screw (see diagram 1). Tighten. Continue fixture ground wire and connect to supply ground wire (usually green or bare copper) using wire nut (C).
- NOTE: It is imperative that the fixture is grounded.
- Connect fixture neutral wire (white) to the supply neutral wire (usually white) using wire nut (C).
- Connect fixture hot wire (black) to the supply hot wire (usually black) using wire nut (C).
- CAUTION: Do not reverse the hot and neutral connections.
- Make sure all wire connections are tight, then carefully tuck into the junction box.
- Install fixture to mounting plate (A) and secure with screws (D).
- Install shade bracket (G) to the socket (H).
- Install metal shade (E) to shade bracket (G) and secure with threaded caps (F).
- Install light bulb into socket (H).
Care Instructions: Clean only with a soft dry cloth or feather duster. Do not use abrasive or chemical agents.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>