gorenje WHU629EX-S Cooker Hood Instruction Manual
- October 30, 2023
- Gorenje
Table of Contents
WHU629EX-S Cooker Hood
Instruction
Manual
WHU629EX-S Cooker Hood
COOKER HOOD
Closely follow the instructions set out in this manual. All responsibility,
for any eventual inconveniences, damages or fires caused by not complying with
the instructions in this manual, is declined. The hood is conceived for the
suction of cooking fumes and steam and is destined only for domestic use.
The hood can look different to that illustrated in the drawings in this
booklet. The instructions for use, maintenance and installation, however,
remain the same.
It is important to conserve this booklet for consultation at any moment. In
the case of sale, cession or move, make sure
it is together with the product.
Read the instructions carefully: there is essential information about
installation, use and safety Do not carry out electrical or mechanical
variations on the product or on the discharge conduits.
Before proceeding with the installation of the appliance verify that there are
no damaged all components. Otherwise contact your dealer and do not proceed
with the installation.
Note: the elements marked with the symbol “(*)” are optional accessories
supplied only with some models or elements to purchase, not supplied.
CAUTION
WARNING! Do not connect the appliance to the mains until the
installation is fully complete.
Before any cleaning or maintenance operation, disconnect hood from the mains
by removing the plug or disconnecting the mains electrical supply.
Always wear work gloves for all installation and maintenance operations.
The appliance is not intended for use by children or persons with impaired
physical, sensorial or mental faculties, or if lacking in experience or
knowledge, unless they are under supervision or have been trained in the use
of the appliance by a person responsible for their safety.
This appliance is designed to be operated by adults, children should be
monitored to ensure that they do not play with the appliance.
This appliance is designed to be operated by adults. Children should not be
allowed to tamper with the controls or play with the appliance.
Never use the hood without effectively mounted grating!
The hood must NEVER be used as a support surface unless specifically
indicated.
The premises where the appliance is installed must be sufficiently ventilated,
when the kitchen hood is used together with other gas combustion devices or
other fuels.
The ducting system for this appliance must not be connected to any existing
ventilation system which is being used for any other purpose such as
discharging exhaust fumes from appliances burning gas or other fuels.
The flaming of foods beneath the hood itself is severely prohibited.
The use of exposed flames is detrimental to the filters and may cause a fire
risk and must therefore be avoided in all circumstances.
Any frying must be done with care in order to make sure that the oil does not
overheat and ignite. Accessible parts of the hood may become hot when used
with cooking appliance.
With regards to the technical and safety measures to be adopted for fume
discharging it is important to closely follow the regulations provided by the
local authorities.
The hood must be regularly cleaned on both the inside and outside (AT LEAST
ONCE A MONTH).
This must be completed in accordance with the maintenance instructions
provided in this manual). Failure to follow the instructions provided in this
user guide regarding the cleaning of the hood and filters will lead to the
risk of fires.
Do not use or leave the hood without the lamp correctly mounted due to the
possible risk of electric shocks.
We will not accept any responsibility for any faults, damage or fires caused
to the appliance as a result of the non-observance of the instructions
included in this manual.
This appliance is marked according to the European directive 2002/96/EC on
Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is
disposed of correctly, you will help prevent potential negative consequences
for theenvironment and human health, which could otherwise be caused by
inappropriate waste handling of this product.
The symbol ****on the product, or on the documents accompanying the product, indicates that this appliance may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment. Disposal must be carried out in accordance with local environmental regulations for waste disposal. For further detailed information regarding the process, collection and recycling of this product, please contact the appropriate department of your local authorities or the local department for household waste or the shop where you purchased this product.
Appliance designed, tested and manufactured according to:
- Safety: EN/IEC 60335-1; EN/IEC 60335-2-31, EN/IEC 62233.
- Performance: EN/IEC 61591; ISO 5167-1; ISO 5167-3; ISO 5168; EN/IEC 60704-1; EN/IEC 60704-2-13; ISO 3741;EN 50564; IEC 62301.
- EMC: EN 55014-1; CISPR 14-1; EN 55014-2; CISPR 14-2; EN/IEC 61000-3-2; EN/IEC 61000-3-3.
Suggestions for a correct use in order to reduce the environmental impact: Switch ON the hood at minimum speed when you start cooking and kept it running for few minutes after cooking is finished. Increase the speed only in case of large amount of smoke and vapor and use boost speed(s) only in extreme situations. Replace the charcoal filter(s) when necessary to maintain a good odor reduction efficiency. Clean the grease filter(s) when necessary to maintain a good grease filter efficiency. Use the maximum diameter of the ducting system indicated in this manual to optimize efficiency and minimize noise.
Additional Installation Specifications:
Use only the fixing screws supplied with the product for installation or, if
not supplied, purchase the correct screws type. Use the correct length for the
screws which are identified in the Installation Guide.
In case of doubt, consult an authorized service assistance center or similar
qualified person.
WARNING! Failure to install the screws or fixing device in accordance
with these instructions may result in electrical hazards.
USE
The hood is designed to be used either for exhausting or filter version.
Exhaust version
In this case the fumes are conveyed outside of the building by means of a
special pipe connected with the connection ring located on top of the hood.
Attention! The exhausting pipe is not supplied and must be purchased apart.
Diameter of the exhausting pipe must be equal to that of the connection ring.
In the horizontal runs the exhausting pipe must be slightly slanted (about
10°) and directed upwards to vent the air easily from the room to the outside.
Attention! If the hood is supplied with active charcoal filter, then it must
be removed.
Connect the hood and discharge holes on the walls with a diameter equivalent
to the air outlet (connection flange).
Using the tubes and discharge holes on walls with smaller dimensions will
cause a diminution of the suction performance and a drastic increase in noise.
Any responsibility in the matter is therefore declined
- Use a duct of the minimum indispensable length.
- Use a duct with as few elbows as possible (maximum elbow angle: 90°)
- Avoid drastic changes in the duct cross-section.
- Use a duct as smooth as possible inside.
- The duct must be made of certified material.
Filter version
One active charcoal filter is needed for this and can be obtained from your
usual retailer.
The filter removes the grease and smells from the extracted air before sending
it back into the room through the upper outlet grid.
INSTALLATION
The minimum distance between the supporting surface for the cooking equipment
on the hob and the lowest part of the range hood must be not less than 50cm
from electric cookers and 65cm from gas or mixed cookers.
If the instructions for installation for the gas hob specify a greater
distance, this must be adhered to.
Electrical connection
The mains power supply must correspond to the rating indicated on the plate
situated inside the hood. If provided with a plug connect the hood to a socket
in compliance with current regulations and positioned in an accessible area,
after installation. If it not fitted with a plug (direct mains connection) or
if the plug is not located in an accessible area, after installation, apply a
double pole switch in accordance with standards which assures the complete
disconnection of the mains under conditions relating to over- current category
III, in accordance with installation instructions.
Warning! Before re-connecting the hood circuit to the mains supply and
checking the efficient function, always check that the mains cable is
correctly assembled.
The hood is provided with a special power cable; if the cable is damaged,
request a new one from Technical Service.
Mounting
Very heavy product; hood handling and installation must be carried out by
at least two persons. Before beginning installation:
- Check that the product purchased is of a suitable size for the chosen installation area.
- Remove the charcoal (*) filter/s if supplied (see also relative paragraph). This/these is/are to be mounted only if you want to use the hood in the filtering version.
- Check (for transport reasons) that there is no other supplied material inside the hood (e.g. packets with screws (), guarantees (), etc.), eventually removing them and keeping them.
- If possible, disconnect and move freestanding or slide -in range from cabinet opening to provide easier access to rear wall/ceiling. Otherwise put a thick, protective covering over countertop, cooktop or range to protect from damage and debris. Select a flat surface for assembling the unit. Cover that surface with a protective covering and place all canopy hood parts and hardware in it.
- In addition, check whether near the installation area of the hood (in the area accessible also with the hood mounted) an electric socket is available, and it is possible to connect a fumes discharge device to the outside (only suction version).
- Carry out all the masonry work necessary (e.g. installation of an electric socket and/or a hole for the passage of the discharge tube).
Expansion wall plugs are provided to secure the hood to most types of walls/ceilings. However, a qualified technician must verify suitability of the materials in accordance with the type of wall/ceiling. The wall/ceiling must be strong enough to take the weight of the hood. Do not tile, grout or silicone this appliance to the wall. Surface mounting only.
OPERATION
Use the high suction speed in cases of concentrated kitchen vapors. It is recommended that the cooker hood suction is switched on for 5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approximately after terminating cooking.
Control Panel
A – Light button
B – Power off button
C – Speed level buttons
To switch the extractor light on or off
Press button A.
To switch on the extractor or to change the speed at any time when the
extractor is running • Press button C for the first, second or third speed
level as required.
To switch the extractor off Press button B.
MAINTENANCE
ATTENTION! Before performing any maintenance operation, isolate the hood from
the electrical supply by switching off at the connector and removing the
connector fuse.
Or if the appliance has been connected through a plug and socket, then the
plug must be removed from the socket.
Cleaning
The cooker hood should be cleaned regularly (at least with the same frequency
with which you carry out maintenance of the fat filter) internally and
externally. Clean using the cloth dampened with neutral liquid detergent. Do
not use abrasive products.
DO NOT USE ALCOHOL!
WARNING: Failure to carry out basic cleaning recommendations of the
cooker hood and replacement of the filters may cause fire risks. Therefore, we
recommend observing these instructions. The manufacturer declines all
responsibility for any damage to the motor or any fire damage linked to
inappropriate maintenance or failure to observe the above safety
recommendations.
Filters
Grease metal filter traps cooking grease particles. The grease filter must be
cleaned once a month using non-aggressive detergents, either by hand or in the
dishwasher, which must be set to a low temperature and a short cycle. When
washed in a dishwasher, the grease filter may discolor, but this does not
affect its filtering capacity. To remove the grease filter, pull the spring
release handle.
Grease paper (synthetic) filter should be replaced at least every two months
or whenever the color becomes visible through the holes of the grille. The
paper filter is colored on one side. This color should not be visible through
the grille holes when the filter is installed.
Charcoal filter (filter version only) absorbs unpleasant odors caused by
cooking. The saturation of the charcoal filter occurs after prolonged use,
depending on the type of cooking and the regularity of cleaning of the grease
filter. In any case it is necessary to replace the cartridge at least every
four months. The charcoal filter may NOT be washed or regenerated.
Replacing lamps
The hood is equipped with a lighting system based on LED technology. The LEDs
guarantee an optimum lighting, a duration up to 10 times as long as the
traditional lamps and allow to save 90% electrical energy.
Replace the damaged lamp. Use E14 LED 4Wx1 lamps only.
For more details check the installation drawings no. 20 and no. 21 in the
manual.
Energy saving tips
- When you start cooking, switch on the cooker hood at minimum speed, to control moisture and remove cooking odor
- Use boost speed only when is strictly necessary
- Increase the range hood speed only when the amount of vapor makes it necessary
- Keep range hood filter(s) clean to optimize grease and odor efficiency.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>