Gorenje JC200BE Juicer Instruction Manual

Juicer
JC200BE VITAWAY
Instruction manual

JC200BE Juicer

WHEN USING ELECTRICAL APPLIANCES, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED, INCLUDING THE FOLLOWING.

1. Power of 230V/50Hz shall be supplied to this product. Please confirm your power supply before use.

2. Be sure to disconnect the power supply before dis-assembly/re-assembly or adjustment to this product.

3. In case of any damage to the flexible wire, to avoid any hazard, contact our customer service or send it to our authorized service center for replacement, and do not try to disassemble it without our authorization.

4. Prior to use, please check the Power Cable, Plug, Juicing Screen, Auger, Housing and other parts. In case of any damage, stop using this product and  contact our customer service immediately without unauthorized dis-assembly or repair to avoid any potential hazard.

5. Before connecting with power supply, make sure that any removable parts such as Drum, Auger, Juicing Screen and End Cap have been mounted in place.
   Note: Before plug in the power cord, confirm that machine is switch to “O” mode to avoid danger.

6. Do Not put your fingers or other objects into the Feed Chute while it is in operation. If food becomes lodged in the Feed Chute, only use the Plunger or another piece of fruit to push it down, any other objects to push the ingredients would cause danger to user or damage to the machine. When this method is not possible, turn the motor off and disassemble the Drum to remove the remaining food.

7. The food ingredients needs to be cut into proper pieces so as to pass through the Feed Chute. Any fruit/vegetable shall have any hard core, seed, skin or shell removed before processing.

8. Proper force shall be used to push the food/vegetables in, not excessive but sufficient to have it squeezed exactly.

9. The Juicing Screen, Auger, or End Cap may be dyed by the juice during operation, which is normal phenomenon and has no effect on edibility and does no harm to health.

10. This product is equipped with intelligent protection chips, making it stop automatically for every 20 minutes operation. And in such case, rest it for more than 20 minutes before restarting it, so as to cool the motor down and prolong its service life.

11. This product is designed to limit the flow rate. During processing of any hard material, the motor would be locked and the current will rise up. When the current goes higher than 1.3A, appliance will beep and the motor will stop for over-current protection and extension of life span.

12. In case that current limit protection is triggered or the motor is locked and stops automatically, switch to “O” position to discharge the food ingredients and then press the button to “ON” position to restart the appliance. If the problem continues, it is recommended to remove any food ingredients inside auger before restart so as to protect the motor.

13.  After the completion of operation, remove any removable part only after the Motor/Auger/Juicing Screen /grinder screw has stopped rotating and the power has been disconnected.

14. To protect against risk of electrical shock, do not put the Housing in water or other liquid.

15. Do not use any steel wool, abrasive cleaning agent or corrosive liquid such as gasoline or acetone to clean this product.

16. This product should be stored in a place that children can’t reach. Not allow persons with unsound extremities and sensation or mental disorders and persons who are short of relate experience and knowledge (including children) to use or play with this product.

17. This product is used for individual or family only.

18. This product is of Class-I protection grade, and the socket used for it must be ground properly.

PARTS AND FUNCTION

power output.
3| Mode switch| It controls the operating statuses (ON, 0 and Rev) of the appliance.
4| Locking Button| For locking of Drum to prevent unexpected release out of the Housing. To unload the Drum off the housing, press down and hold this button.
5| Juice Cup| To hold and collect the juice extracted by the extractor.
6| Pulp Container| To hold and collect any Pulps separated by the extractor.
7| Plunger| To squeeze and make the load food ingredients contact completely with the auger so as to maximize extracting efficiency.
8| Tray| For interim storage of food ingredients to process.
9| Drum| One of the main components to extract juice, where the food ingredients is loaded from the Feed chute at the top, while the juice and Pulps are discharged from the outlet.
10| Auger| One of the main components to extract juice, where the food ingredients is squeezed towards the Juicing Screen.
11| Juicing screen| Work with Auger to squeeze food ingredients and filter the juice (applicable to fruits, vegetables and beams)
12| End cap| Coupled with the Drum to provide protection.
13| Feed Chute| Feeding food and load down to Drum
14| Anti- drip Valve| When valve closed, juice would not come out

METOD OF OPERATION

Before using the appliance for the first time, clean its parts in contact with food ingredients thoroughly .

| Button Operation:
3 MODES:
0: When finish juicing, switch to this mode to stop appliance.
Note: Before plug in the power cord, confirm that machine is switch to “O” mode to avoid danger.
ON: When juicing, switch to “ON” mode.
REV: Switch to “REV” mode to tum out the pulp, just press down the button to “REV” mode and don’t release.
Note: When release, switch would tum back on “O” mode, then machine stops.
---|---

Assembly instruction

1. Connect the Drum > 9 < with housing > 2 <.
   Connect the Drum® with Housing > 2 < by aligning the two humps on Drum with two notches on the Housing, push the Drum straightly, you will hear “Tick” sound to confirm fastening it tightly and correctly.

2. Place the Auger > 10 < into the Drum> 9<.

3. Align the notch of Juicing Screen > 11 < with the bulge of Drum > 9 <, and then insert it straight into Drum > 9 <.

4. Place the End Cap onto the Drum > 9 < end and rotate the End Cap anticlockwise.
   Align the triangle alignment mark ▲ on the End Cap with the unlock mark on the Drum > 2 < and then rotate the End Cap anticlockwise to fasten it.

5. Put the Juice Cup > 2 < onto the corresponding groove of Housing and have its opening align with the bottom of the juice outlet of the Housing.

6. Place the Pulp Container > 2 < under the Drum set.

7. Connect the power supply for use of the appliance.
   Note: Make sure the switch is on the “O” position before the power supply is connected.

8. Clean food ingredients and cut it into small pieces sufficiently which can pass through the Feed Chute, and place them onto the Tray.
   Note: Any hard cores, seeds, skin or shell from fruits and vegetables shall be removed in advance. Prepared food ingredients should be juiced in time, because Oxidized fruits or vegetables would cause more foam generating.

9. Anti-drip Function
   Featured with freely adjustable Anti-drip Valve, no waste of juice while keeping your countertop clean.
   Open-When Juicing, rotate the Anti-drip Valve anticlockwise to tum on.
   Close-When juicing finished, rotate the Anti-drip Valve clockwise to close to avoid juice leaking.

10. Switch to “ON” mode to start juicing.
    Note:
    1.Keep the machine operating for less than 10 minutes. Long time working would cause damage to the motor.
    2. Do not touch the power switch with wet hand to avoid electric shock,leakage or fire.

11. Place few pieces of cut fruits or vegetables into the Feed Chute, push them down the Drum gently with Plunger > 7 <.
    Proper force shall be used to push the food ingredients in, not excessive but sufficient to have it squeezed exactly.
    Note: Only Plunger can be used to push the ingredi­ ents, any other objects would cause danger to user or damage to the machine!
    2. Do not touch the power switch with wet hand to avoid electric shock, leakage or fire.

12. 1. Upon completion, shut down the switch when no juice flowing out of the outlet and disconnect the power supply. Do not remove the Juice Cup off the outlet until the Auger and Juicing Screen have stopped rotating completely and make sure the anti-drip valve has been close.
    2. The extracted juice should be drunk as soon as possible as it will have degraded taste and nutrient content if
    The Pulps shall not be stored for a long time
    Do not touch the power switch with wet hand to avoid electric shock, leakage or fire.

FRUIT JUICE EXTACTOR
Efficiently juices hard and soft fruits: even citrus fruits, usually one of the hardest fruits to juice.
Jam could not be achieved. Some fruit could not be squeezed juice (such as bananas, mangoes, dried fruit, sugar cane, etc.
VEGETABLE JUICE
Cut vegetables to strips (less than 10cm ).
Juices all kinds of vegetables including carrots, apples , celery,cucumber and radishes without destroying the natural flavor and nutrition benefits. Fresh taste and full nutrition are guaranteed with this unique extraction process.
When juicing tomatoes, some pulp would stay in the Drum because tomatoes change to mushy easily. Juice would come out normally. It is normal phenomenon for masticating juicer.
WHEATGRASS AND LEAFY GREENS
Cut it to strips (less than 10 cm )
Wheat grass, kale, cabbage, spinach are just some of the natural food ingredients that can be juiced with the juicer. Enjoy the best that nature offers in raw foods of all kinds and juice them for full nutritional benefits. Prepared food ingredients should be juiced in time, because Oxidized fruits or vegetable would cause more foam generating.

INSTRUCTIONS ON SELECTION OF FRUITS

1. Select fresh fruits and vegetables, which contain more juice. The proper fruits include pineapple, celery stalk, apple, cucumber, spinach, melons, orange and grape.
2. Thick skin fruits such as orange, pineapple and raw beet root need to be removed. Seeds in oranges, lemons and apples should be removed as well, which may cause a little bitter taste of the juice or unpleasant noise.
3. Concentration of juice extracted from apple depends on what type of apple is selected. Juice extracted from juicy apple is less thick, so select the proper type of apple depending on your desired juice concentration.
4. Just squeezed apple juice will turn brown very soon, and this process can be slowed by adding drops of lemon juice into it.
5. Leaves and stems (such as those of lettuce) can be put into the extractor to extract juice.

Disassembly instruction

1. Before cleaning this product, be sure to shut down the switch to disconnect the power supply.
2. Clean this product after using it.
3. The Housing cannot be washed under water, and must be cleaned with twisted wet cloth instead.
4. Before storing it, make sure this product is clean and dry.
5. Disassemble this product to wash the components by the following steps.1.First remove the Plunger > 7 < .
   2.Remove the Pulp Container.
   3.Remove the Juice Cup.4.Rotate the End Cup clockwise to take it out.
   5. Pull out the Juicing Screen straightly.Note: No need to rotate.
   6.Pull the Auger straightly to take it out. 7.Press the Locking Button >4< on the side of the Housing and pull out the Drum >9< straightly at the same time to take it out. The Drum cannot be disassembled if the button is not pressed.

After connecting power supply and turning on the switch, after ls, the product still no work.| 1.After turning on the machine, please wait for
Is. It will work normally.
2.If it does not work, maybe poor contact between plug and socket.| Re-plug it properly.
Replace the socket and try again or contact after Sales Support.
During the early uses the motor generates unpleasant smell.| It is a normal phenomenon. sales support| If this phenomenon occurs frequently,contact after
When juicing, juice does not come out.| Check the anti-drip valve, make sure that it is on open state.| Open the anti-drip valve. Rotate the valve switch anticlockwise to open the anti-drip valve.
This machine stops during operation.| I. Too low voltage
2.Excessive amount of food ingredients.
3.The machine has
operated continuously for long time.| 1.Check whether the voltage is too low.
2.Disconnect the power supply and remove excessive food
ingredients.
3.It is a normal phenomenon and the motor will resume after a break time.
Noise is generated during operation.| 1.The machine operates in an unbalanced state due to failure to mount Auger or Juicing Screen in place.
2.The starting motor in the frame has been damaged.| Mount Auger or Juicing Screen in place or contact after sales support

This appliance is marked according to the European directive 2012/19/Eu on Waste Electrical and Electronic Equipment (WEEE).This guideline is the frame of a European-wide validity of return and recycling on Waste Electrical and Electronic Equipment.

Environment

Do not throw away the appliance with the normal household waste at the end of its life, but hand it in at an official collection point for recycling. By doing this, you help to preserve the environment.

Guarantee & service

If you need information or if you have a problem, please contact the Gorenje Customer Care Centre in your country (you find its phone number in the worldwide guarantee leaflet). If there is no Customer Care Centre in your country, go to your local Gorenje dealer or contact the Service department of Gorenje domestic appliances. For personal use only!
We reserve the right to any modifications !
GORENJE
WISHES YOU A LOT OF PLEASURE WHEN USING YOUR APPLIANCE

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>