VISUAL COMFORT TOB2512 Alpha Large Convertible Sconce Instruction Manual
- October 30, 2023
- VISUAL COMFORT
Table of Contents
VISUAL COMFORT TOB2512 Alpha Large Convertible Sconce Instruction Manual
Alpha Large Convertible Sconce
Item # TOB2512
NOTICE:
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction and
operation of it, as well as the hazards involved.
Inspect item and contents carefully.
If any damage or defect is found, do not install.
Retain all packaging material until installation is complete and approved.
TOOLS REQUIRED (NOT INCLUDED):
- Phillips Screwdriver
- Slotted Screwdriver
- Scissors
ASSEMBLY INSTRUCTIONS
Option 1
-
Carefully remove all parts from the box.
Place on a clean, soft surface. -
Remove mounting plate (D) from fixture by removing screws (E).
-
Install mounting plate (B) to the junction box and secure with the mounting screws (C).
-
Wrap fixture ground wire (bare copper) around the green grounding screw (see diagram 1 ). Tighten.
Continue fixture ground wire and connect to supply ground wire (usually green or bare copper) using wire nut (A).
NOTE: It is imperative that the fixture is grounded. -
Connect fixture neutral wire (white) to the supply neutral wire (usually white) using wire nut (A).
-
Connect fixture hot wire (black) to the supply hot wire (usually black) using wire nut (A).
CAUTION: Do not reverse the hot and neutral connections. -
Make sure all wire connections are tight, then carefully tuck into the junction box.
-
Install fixture (D) to mounting plate (B) and secure with screws (E).
-
Thread shade riser (G) to fixture (D) top threaded nipple.
-
Install light bulbs into sockets.
-
Install shade (H) split washer below knurled ring (K) and secure by screwing tight.
-
Install diffuser (I) to shade riser (G) and secure with finial (J) .
Care Instructions: Clean only with a soft dry cloth or feather duster.
Do not use abrasive or chemical agents.
Option 2
-
Carefully remove all parts from the box.
Place on a clean, soft surface. -
Remove mounting plate (D) from fixture by removing screws (E).
-
Install mounting plate (B) to the junction box and secure with the mounting screws (C).
-
Wrap fixture ground wire (bare copper) around the green grounding screw (see diagram 1). Tighten.
Continue fixture ground wire and connect to supply ground wire (usually green or bare copper) usingwire nut (A).
NOTE: It is imperative that the fixture is grounded. -
Connect fixture neutral wire (white) to the supply neutral wire (usually white) using wire nut (A).
-
Connect fixture hot wire (black) to the supply hot wire (usually black) using wire nut (A).
CAUTION: Do not reverse the hot and neutral connections. -
Make sure all wire connections are tight, then carefully tuck into the junction box.
-
Install fixture (D) to mounting plate (B) and secure with screws (E) .
-
Thread shade riser (G) to fixture (D) top threaded nipple.
-
Install light bulbs into sockets.
-
Install shade (H) split washer below knurled ring (L) and secure by screwing tight.
-
Install diffuser (I) to shade riser (G) and secure with finial (J) .
Care Instructions: Clean only with a soft dry cloth or feather duster.
Do not use abrasive or chemical agents.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>