luminii LLWD68WET-T Line LED Wet 24V Instruction Manual
- June 11, 2024
- luminii
Table of Contents
LineLED Wet 24V – Installation Instructions
Models LLWD68WET-T
LLWD68WET-T Line LED Wet 24V
Please read all instructions prior to installation and keep for future reference!
- PRODUCT SHOULD BE INSTALLED BY A QUALIFIED ELECTRICIAN
- ENSURE POWER IS OFF AT FUSE BOX PRIOR TO INSTALLATION TO PREVENT ELECRICAL SHOCK
- USE ONLY WITH CLASS 2 POWER UNIT
- SUITABLE FOR WET LOCATIONS
- FOR UNDER-CABINET OR SHELF MOUNT
- AVOID EXPOSURE TO DIRECT SUNLIGHT
- NOT SUITABLE FOR APPLICATIONS WHERE LEDS CAN BECOME SUBMERGED
1.1 Remove paper backing from the lineLED and firmly press down. Making sure
there are no air bubbles that can cause surface irregularities to the lineLED.
Do not remove the adhesive, removing the adhesive may cause arcing of the
lineLED tape.
1.2 If necessary, add a mounting clip every 12” for additional support.
3 RECOMMENDED LAYOUT FOR MULTIPLE ADJACENT RUNS OF LINELED FED WITH SEPARATE
POWER SUPPLIES
Position power supplies either in the middle of two runs or at the opposite
ends.
Always
ensure power to power supply is off! Follow diagrams to connect power feed
wires to power supply. Refer to powersupply instructions for wiring line
voltage side.
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE
REV0.2
0 111 2 0 2 3
2 / 2
7777 Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
info@luminii.com
www.luminii.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>