CAL-ROYAL N-MR77 N-MRESC Escutcheon Trim For Exit Device Instructions

CAL-ROYAL N-MR77 N-MRESC Escutcheon Trim For Exit Device

The Cal-Royal NMRESC Trim is designed to be used with N-MR7700/N-MR9800 Series Mortise Exit Devices. The trim is available in different models, including NMRESC-7700, NMRESC-7730, NMRESC-7740, NMRESC-7705, NMRESC-9800, NMRESC-9830, NMRESC-9840, and NMRESC-9805.

Product Usage Instructions

1. Exit Device Chasis: This is a mortise chassis that can be locked and unlocked with a key. To open the device, pull the mortise lock lever.
2. NoCyl, Trim Always Operable: This is a dummy esc lever trim that can be operated even when the push bar is locked down. Pull the trim to open the door.
3. Pull when Push Bar Locked Down Dummy Esc Lever Trim: This is another type of dummy esc lever trim that can only be operated by pulling it when the push bar is locked down.
4. Rigid Lever, Cyl Esc Lever Trim: This is a lever trim that can be operated with a cylinder. It has a rigid lever and a cylinder escutcheon.
5. 00 function Entrance: This is an entrance function lever trim that can be used with a mortise lock. To install it, attach the collar and mortise cylinder to the escutcheon case with a mortise nut. Then, attach the case to the door using two screws to the chassis, aligning the spindle to the hub.
6. 30 function Passage: This is a passage function lever trim that can be used without a lock. To install it, attach the escutcheon case to the door using two screws to the chassis, aligning the spindle to the hub of the chassis.
7. 40 function Dummy: This is a dummy lever trim that cannot be operated. To install it, attach the collar and dummy cylinder to the escutcheon case with a mortise nut. Then, attach the case to the door using two screws to the chassis.
8. 05 function Storeroom: This is a storeroom function lever trim that can be locked from the outside using a key, but can be opened from the inside without a key. To install it, attach the collar and mortise cylinder to the escutcheon case with a mortise nut. Then, attach the case to the door using two screws to the chassis, aligning the spindle to the hub.

INSTRUCTIONS

Method of Change Handing of Lever LHR/RHR

LHR

1. Lever Trim shipped and supplied. with lever positioned neutral, Non-Handed.
2. Rotate lever to desired hand, LHR, position at 90°~95°.
3. Fasten guide stop plate to case.
4. Done.

RHR

1. Lever Trim shipped and supplied with lever positioned neutral, Non-Handed.
2. Rotate lever to desired hand, RHR, position at 90°~95°.
   • Fasten guide stop plate to case.
3. Done.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>