ET2 E24605-122PC LED Wall Sconce Instruction Manual
- June 9, 2024
- ET2
Table of Contents
ET2 E24605-122PC LED Wall Sconce
Before Getting Started
Read the instructions carefully prior to assembling the product
When you open the package with a sharp tool like a cutter knife, be careful
not to damage the components inside.
Carefully remove all packaging materials and retain for future use.
Keep all hardware parts and packaging out of reach of small children.
Choose a clean, level, spacious assembly area.
Avoid hard surfaces that may damage the product.
Ensure that you have all required contents for complete assembly.
Take care when lifting. Assemble the product in close proximity to where you
intend to position the item.
Do not over tighten the screws and bolts as this may damage the threads.
Do not let children play with this product.
- Risk of suffocation!
Keep anypackaging materials away from children.
Low Voltage LED Lighting Instructions
Carefully read through the instruction sheet before assembly and using the
product.
Caution there is a risk of shock. Disconnect from power source before
assembling or cleaning.
WARNING: Wires need to be connected to driver found in canopy and should
not be connected directly to power source or a short may occur.
Do not cut factory connections unless instructed by the manufacturer
Do not plug the product in if cord is torn or frayed.
Cleaning & Maintenance
On polished finishes, often using talc powder reduces the appearance of
fingerprints and other smudges.
For respective shade surfaces, use the appropriate cleansers, i.e. glass
cleaner, acrylic polish, and wood polish.
Clean with soft cloth and a mild detergent.
DO not use abrasive cleaner.
Periodically (every 90 days) make sure that the screws are fully tightened.
Prolonged exposure to heat sources may cause glazing, melting and scorching,
or even cause color to fade.
Contents
Before getting, started, ensure the package Contains the following components:
A
| |
x1
---|---|---
B
| | x1
C|
SCREWS L0.47″|
x2
D
|
SCREWS 8#-32N 1″|
x2
E
| | x3
F|
SCREWS L0.63″|
x4
G
|
CRYSTAL#ECRY24605-122B| x1
H|
cRYSTAL#ECRY24aos-122A|
x1
I
| |
x1
Assembly
Note: The crystal points should face outward when assembling.
WIRING DIAGRAM (ONLY FOR REFERENCE)
DO NOT ATTEMPT TO CUT FACTORY CONNECTIONS WITHOUT QUALI ED
KNOWLEDGE.MODIFICATIONS MADE TO THIS PRODUCT WITHOUT THE CONSENT OF THE
MANUFACURER WILL VOID WARRANTY.
**SCHEMATIC FOR GENERAL REFERENCE ONLY
**
THIS FIXTURE HAS BEEN TESTED TO DIM WITH…
Lutron DVCL-153P
Lutron DVELV-300P
Must be installed by a licensed electrician with
knowledge of electronic lighting systems
Documents / Resources
| ET2
E24605-122PC LED Wall
Sconce
[pdf] Instruction Manual
E24605-122PC LED Wall Sconce, E24605-122PC, LED Wall Sconce, Wall Sconce,
Sconce
---|---