ET2 E25090-01BKGLD Mobius LED Table Lamp Instruction Manual
- June 9, 2024
- ET2
Table of Contents
ITEM NUMBER: E25090-01BKGLD
DESCRIPTION: JMOBIUS LED LAMP
PLEASE CONSULT AN ELECTRICIAN BEFORE INSTALLATION
LAMPING: LED Integrated 13W
Vinput: 110-240V
MADE IN CHINA
LED Lighting (LOW VOLTAGE)
Before Getting Started
Read the instructions carefully prior to assembling the product.
When you open the package with a sharp tool like a cutter knife, be
carefulness to damage the components inside.
Carefully remove all packaging materials and retain for future use.
Keep all hardware reports and packaging out of reach of small children.
Choose a clean, level, spacious assembigrea.
Avoid hard surfaces that may damage the product.
Ensure that you have all requi reconsents for complete assembly.
Take care when lifting. Assemble the product in close proximity to where you
intend to position the item.
Do not over tighten the screws and bolts as this may damage the threads.
Do not let children play with this product.
+ Risk of suffocation!
Keep any packaging matata’s away from children.
Low Voltage LED Lighting Instructions
Carefully read through the instruction sheet before assembly and using the
product.
Caution there is a risk of shock. Disconnect from power source before
assembling or cleaning.
WARNNG: Wires need to be connected to driver found in canopy and should
not be connected directly to power source or a short may occur.
Do not cut factory connections unless instructed by the manufacturer
Do not plug the product in if cord is torn or frayed.
Cleaning & Maintenance
On polished finishes, often using talc powder reduces the appearance of
fingerprints and other smudges.
For respective shade surfaces, use the appropriate cleansers, i.e. glass
cleaner, acrylic polish, and wood polish.
Clean with soft cloth and a mild detergent.
DO not use abrasive cleaner.
Periodically (every 90 days) make sure that the screws are fully tightened.
Prolonged exposure to heat sources may cause glazing, melting and scorching,
or even cause color to fade.
Contents
Before getting, started, ensure the package contains the following components: