ET2 E21263 Penrose 24 Inch LED Sconce Instruction Manual
- June 10, 2024
- ET2
Table of Contents
E21263 Penrose 24 Inch LED Sconce
Instruction Manual
Item/Model: E21263
PENROSE 24” LED SCONCE
Lamping : LED ntegrated 30W
Made in China
Before Getting Started
Read the instructions carefully prior to assembling the product. When you open
the package with a sharp tool like a box knife, be careful not to damage the
components inside. Carefully remove all packaging materials and retain for
future use.
Keep all hardware parts and packaging out of reach or small children.
Choose a clean, level, spacious assembly area. Avoid hard surfaces that may
damage the product.
Ensure that you have all required contents for complete assembly.
Take care when lifting. Assemble the product in dose proximity to where you
intend to install it.
Do not over tighten the screws and bolts as this may damage the threads. Do
not let children play with this product.
Risk of suffocation!
Keep packaging materials away from children.
Lamp Care Instructions
Carefully read through the instruction sheet before assembly and using the
product.
Caution thereisa risk of shock
Disconnect from power source before assembling or cleaning.
Switch off, unplug and allow bulb to cool before replacing bulb or cleaning.
Only use the recommended bulb type and do not exceed the maximum wattage as it
could cause fire.
Check the product cord to be sure is free torn or frayed.
WARNING: Wires must to be connected to low voltage driver and should not
be connected directly to live wire or a short may occur.
Cleaning & Maintenance
On polished finishes, often using talc powder can reduce the appearance of
fingerprints and other smudges. For respective shade surfaces, use the
appropriate cleansers, i.e. glass cleaner, stone polish, & wood polish.
Clean with soft cloth and a mild detergent. Do not use abrasive or harsh
cleaners.
Periodically (every 90-180 days) make sure that the screws are fully
tightened.
Prolonged exposureto heat sourcesmay cause glazing, meltingand scorching,or
even cause color to fade.
PARTS
Before getting,started,ensure the package contains the following components:
WIRING DIAGRAM
DIMMER COMPATIBILITY
ITEM/MODEL: E21263
MUST be installed by an experienced professional CRITICAL KNOWLEDGbf
electronic lighting systemsequired
IMPROPER WIRING and/or INCORRECT DIMMER use ca n cause CATASTROPHIC DAMAGE!
THIS FIXTURE MUST BE INSTALLED with a COMPATIBLE DIMMER SWITCH
DO NOT CUT FACTORY-MADE CONNECTIONS. VERIFIED LIST OF TESTED DRIVERS
Lutron DVCL-153P
Lutron SCL-153P
Leviton IPLO6
Leviton 6674
Deako Simple
Dimmer
Due to inrush current, wattage should not exceeed 150W on a 600W dimmer
GENERAL COMPATIBILITY
TRIAC
IMPORTANT!
If the control is not paired properly to LED fixtures, irreparable damage may
occur.
If the dimmer you are using is not listed here, consult a lighting
professional or view our Dimming Compatibility Chart online:
www.et2online.com
1 ©2023 ET2 CONTEMPORARY LIGHTING
Documents / Resources
| ET2
E21263 Penrose 24 Inch LED
Sconce
[pdf] Instruction Manual
E21263 Penrose 24 Inch LED Sconce, E21263, Penrose 24 Inch LED Sconce, 24 Inch
LED Sconce, LED Sconce, Sconce
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>