DNA 02RSA4511 2007-2013 Chevy Silverado 1500 or 2500HD or 3500HD Fender Flares Instruction Manual
- June 10, 2024
- DNA
Table of Contents
DNA 02RSA4511 2007-2013 Chevy Silverado 1500 or 2500HD or 3500HD Fender
Flares
2007-2013 Chevy Silverado
1500/2500HD /3500HD Fender
Flares Installation Instructions
SKU-02RSA4511
- 7mm Socket
-
2 Ph1lhps Denver
- Grease Pencil
- Scratch Awl
STEP 2
EDGE TRIM INSTALLATION
Press edge trim into place along the the flare with supplied.
Included in Hardware Kit
Front Flare Installation Method (Driver’s Side)
- With a 7mm sleeve, remove four factory screws from the “‘heel housing and store them for re-installation.
- Hold the fender on vehicle anc skirt four factory screws removed 1n <::.tr·1 1. Ven’y Fit and lighten all screws.
- Completed Front Flare installation
- The horn n the proper position on the under Hagen the two holes at the top of fanning ,\1th the factory holes of the :.ii sheet. and use the remaining four ho s At the bell mouth. mark the metal the an o I pen.
- Two factory hole locations. Four marked locations.
- The provided lugs (WT -0005) are plied at the center of all four markers rnittep 4 and the two factory holes to l1gn the lug edges with the runner J1es of the lender edges (the lugs and hands).
- Place The provided clip (WT-0007) in the center of The upper two Rectory holes Noel: The convex Runge on the clamp should face up and enter the interior of the fender Punch a hole in lugs and factory holes with scratch.
- Clip tWT-0001 )locales
- Slide The provided clamp (WT-J002) onto each lug 1n the remaining our positrons. The clamp may need .l be ad1usled lo align With them.
Clip (WT-0002) locales.
- Reposition Off are on fender, Start a supplied Screw (WT-0004) through The two uppermost holes in the Oared and into each Chap installed ,n Step 7
- The supplied screw (WT-0004) is passed through each remaining hole and insane into each damp installed rn step 9 If necessary use .scratcluones lD IC>Cite. holes. t:.age Trim 1 001 usage method:
- In order lo make the edge tam more fit tender ,using supplied Edge Trim Tool (WT-0006), Smooth the edge of the tape ,and slowly shed ,t 10 the other end.
- Vinify fit and lighten all Screws.
- Using Nat end of supplied Edge TN Tool (WT-0006), insert the edge trim ,make more fit with fender.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>