NINGBO KP2238S Wireless Charging Notebook Instruction Manual
- June 10, 2024
- Ningbo
Table of Contents
KP2238S Wireless Charging Notebook
Instruction Manual
KP2238S Wireless Charging Notebook
- Micro USB Power Cable (included)
- Charging Area
- Power Port
Wireless Charging Notebook
Input : DC 5V/2A
Output: 5V/1A
FCC ID: 2AUVH-KP2238S
PO: 61260
Made in China
FCC Part 15:
CAUTION: Risk of Fire and Bums. Do Not Open, Crush, Heat Above 45t/113°F or
Incinerate. Follow Manufacturer’s Instructions.
IMPORTANT SAFETY INSTRUCTIONS
WARNING – When using this product, basic precautions should always be followed, including the following:
- Read all the instructions before using the product.
- To reduce the risk of injury, close supervision is necessary when the product is used near children.
- Do not put fingers or hands into the product.
- Do not expose the product to rain or snow.
- Use of a power supply or charger not recommended or sold by the product manufacturer may result in a risk of fire or injury.
- Do not use the product in excess of its output rating. Overload outputs above rating may result in a risk of fire or injury.
- Do not use the product if it is damaged or modified. Damaged or modified batteries may exhibit unpredictable behavior resulting in fire, explosion or risk of injury]
- Do not disassemble the product. Take it to a qualified service person when a service or repair is required. Incorrect reassembly may result in a risk of fire or injury to persons.
- Do not expose the product to fire or excessive temperature. Exposure to fire or excessive temperature may cause an explosion.
WIRELESS CHARGER OPERATION
- Connect wireless charging notebook to a power source via included micro USB cable.
- Place portable device on center of charging area.
- Phone charges immediately upon contact.
TROUBLESHOOTING
- Always place phone centrally on charger
- Phone case should be less than 4mm (c6″) thick
- Do not use magnetic cases
- Do not use credit card cases
- Do not use cases with metal rings
PRODUCT SPECS
Item No.: KP2236S
Input Specs: DC:5V/2A
Output Specs: 5V/1A
Conversion efficiency: 60%
Accessories: USB cable; wireless charging notebook; instruction sheet.
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
The distance between user and device should be no less than 20cm.
WARNING: Changes or modifications not expressly approved by the party
responsible for compliance could avoid the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
CAUTION:
- Do not expose to moisture, sunlight, or other heat sources.
- Keep away from children and ensure all adults who use this product read and follow these instructions.
- Operation temperature range between 32°F and 113° F.
- Use correct voltage charge, 5V only.