CREATE IRON UP COMPACT Portable Vertical Clothes Steamer User Manual

CREATE IRON UP COMPACT Portable Vertical Clothes Steamer

Thank you for choosing our appliance. Before using the appliance, carefully read these in­structions to ensure it is used correctly.
The safety precautions enclosed reduce the risk of death, injury and electrical shock when correctly followed. Keep the manual in a safe place for future reference, along with the com­pleted warranty card, purchase receipt and package. If applicable, pass these instructions on to the next owner of the appliance. Always follow basic safety precautions and accident prevention measures when using an electrical appliance. We assume no liability for custom­ers who fail to comply with these requirements.

SECURITY INSTRUCTIONS

When using any electrical appliance, basic safety precautions should always be observed.

• The voltage of your electrical source must correspond to that of the appliance (220-240~50/60Hz). Connecting to the wrong voltage may cause permanent damage to the ap­pliance and will invalidate the warranty.
• Do not share a power supply with other high-powered electrical appliances.
• To reduce the risk of electric shock, do not immerse the appliance, plug, or power cord in water or other liquids.
• Do not leave this appliance unattended while switched on.
• Fill with water before use and observe the water level during use.
• Do not use the appliance if the power cord is damaged.
• Never pull on the power cord to unplug the appliance. Always grasp the plug and pull to unplug.
• Do not use outdoors.
• Do not fill the water tank with hot water or corrosive cleaning agents which could cause damage. Use distilled or filtered water to avoid clogging the steam nozzle.
• Burns can occur from touching the hot element, hot water, or steam. To reduce the risk of contact with the hot steam emitted from the steam nozzle, check the appliance before each use by holding it away from the body and operating the steam button.
• When In use, this appliance will spray hot steam from Its steam nozzle. To avoid Injury from hot steam, do not aim the steam nozzle at people or pets.
• Only use SHINIL accessories on your appliance. The use of accessory attachments other than those provided by us may result in fire, electric shock or permanent damage to the appliance.
• Be cautious when installing or removing accessories. Make sure the unit is off to avoid scalding.
• This appliance is not intended for use by children or near children and other persons whose physical sensory, or mental capabilities, or lack of experience and knowledge prevents them from using the appliance safely without supervision or instruction by a responsible person.
• Let the appliance cool completely before putting the unit away. Loop cord loosely around the appliance for storage.

CAUTION:

• Do not leave the steamer unattended while plugged in.
• Always turn off and unplug the appliance before refilling, draining, cleaning, moving or when not in use.

PARTS LIST

1. Water Tank
2. Main Machine
3. Steam Panel
4. Handle
5. Tank Stopper
6. Indicator Light
7. Switch
8. Power Cord
9. Brush
10. Water Measuring Cup

INSTRUCTIONS FOR USE

1. Open the handle to an angle of about 110° degrees until you hear it click into place.
2. Open the water tank stopper and rotate it to one side. Use the measuring cup to pour some water into the tank (Note: do not add too much water as this will stop the steamer working properly).
3. Plug the appliance into an earthed socket (at the appropriate voltage) and wait for about 25 seconds for the indicator light to stop blinking red and stay on red. Press the steam switch and the indicator light will turn blue. The steam will start to come out about 10 seconds later, and then the clothes can be steamed.

INSTALLATION AND ASSEMBLY

CONNECTING THE BRUSH

1. Unplug the steamer and wait for it to stop steaming and cool down completely.
2. Attach the brush to the steam nozzle and fix it in place, with the tab side upwards.

REMOVING THE BRUSH

1. After steaming, turn off the machine and unplug the power cord.
2. Press and hold the tab on the top side of the brush to pull forward and gently pull the brush out.

HOW TO STEAM CLOTHES

1. The most important point is to hold the garment in place firmly, rather than pulling down, and straighten it as much as possible. When steam starts coming from the nozzle, sweep it gently up and down over the clothes to smooth out creases immediately.
2. Steam inside pockets starting at the bottom, then up and down.
3. To steam sleeves, hold them straight and pass the steam nozzle from the shoulder to the cuff, and then up and down.
4. To steam a collar, keep steaming the collar edges for a long time, then pass the steamer backwards and forwards.
5. To steam edges and hems, hold the garment taut and hold the steam nozzle close to the fabric. Pass the steamer nozzle upwards.
6. After steaming the front side, turn clothes around to do the back.

NOTES

1. The steam produced by the appliance is very hot, reaching a top temperature of 160°C, so check before use that the clothes can be steamed at high temperatures, and do not leave the steamer in the same position for a long time, so as not to damage the clothes.
2. When not using the product, empty the water out of the water tank, turn off the steam switch, unplug the steamer and wait for the steam to stop. (If steam is coming from the nozzle, turn off the steam switch and unplug. Be careful because there is still hot water in the tank. The appliance may stay hot for some time).
3. Empty the water out of the water tank, switch off and unplug the steamer until the steam stops. Wait until the product cools before storage.

FAILURE ANALYSIS AND TROUBLESHOOTING

Note: Unplug the appliance before troubleshooting. Pull out the plug.

In compliance with Directives: 2012/19/EU and 2015/863/EU on the restriction of the use of dangerous substances in electric and electronic equipment as well as their waste disposal. The symbol with !he crossed dustbin shown on the package indicates that the product at the end of its service life shall be collected as separate waste. Therefore, any products that have reached the end of their useful life must be given to waste disposal centres specialising in separate collection of waste electrical and electronic equipment, or given back to the retailer at the time of purchasing new similar equipment, on a one for one basis. The adequate separate collection for the subsequent start-up of the equipment sent to be recycled, treated and disposed of in an environmentally compatible way contributes to preventing possible nega­tive effects on the environment and health and optimises the recycling and reuse of components making up the epparatus. Abusive disposal of the product by the user involves application of the administrative sanctions according to the laws.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>