CARVIN PB48 Patch Bay System Instructions
- June 13, 2024
- CARVIN
Table of Contents
CARVIN ENGINEERING DATA
PB48 PATCH BAY
INSTRUCTIONS
PB48 Patch Bay System
Congratulations on your selection of the PB48 Patch Bay System. It is a versatile and easy to use signal router and patch point system. When used in and out of the studio, it will become an indispensable part of your sound system.
RECEIVING INSPECTION
INSPECT FOR ANY DAMAGE which may have occurred during shipping. If any damage
is found, please notify the shipping company & CARVIN.
SAVE THE CARTON & ALL PACKING MATERIALS. In the event you have to re-ship your
unit, always use the original carton and packing material. This will provide
the best possible protection during shipment. CARVIN and the shipping company
are not liable for any damage caused by improper packing.
SAVE YOUR INVOICE. It will be required for warranty service if needed in the
future.
SHIPMENT SHORTAGE. If you find items missing, they may have been shipped
separately. Please allow several days for the rest of your order to arrive
before inquiring.
RECORD THE SERIAL NUMBER on the enclosed warranty card or below on this manual
for your records. Keep your portion of the card and return the portion with
your name and comments to us.
For your records, you may wish to record the following information.
Serial No.__
Invoice Date___
PATCH BAY USE
The PB48 features two closed circuit 1/4” patch points (pairs) on the front
panel and two single contact 1/4” connection (pairs) on the rear panel. A
signal patched into one of the rear panel jacks is routed through the
respective two front panel connections and subsequently returned to the second
rear panel jack (as an output).
The most common use for this patch configuration is for effects “sends and
receives” on a console. It allows the “send” signal from the console to be
rounded through the patch bay and returned to the console via the second rear
output jack. This allows access to the send and return patch points of the
console using the front panel patch points of the PB48.
Another use would be to route a channel “direct output” through the PB48 to a
respective track on a multitrack recorder. This allows in-line signal
processing to be patched (including compressors, noise gates, limiters, etc.)
for each track as well as quick access to re-route signals to alternate
tracks.
PATCH BAY SUMMARY
This patch bay has 48 jacks on the front for patching, and 48 jacks on the back to connect the inputs and outputs of your gear. As shipped from the factory, the up-and down pairs of jacks on the front are wired together in a manner called “half nonmilled’. Each jack pair is built on its own rugged epoxy-glass circuit board and can be easily configured as not nonmilled if desired (no signal connection between upper and lower jack). Remove the mounting nuts from the lower jacks on the back of the patch bay and remove the circuit board 180˚ so the bottom rear jack becomes the upper front jack. Replace the circuit board, remembering to put the mounting nut back on and tighten. You’re done, with no soldering or cutting wires. This patch bay is fitted with 1/4” TRS (Tip-Ring-Sleeve) jacks. They can be used with any standard 1/4” phone plug for balanced, stereo, or unbalanced operation.
SPECIFICATIONS
Dimensions: | 19” x 1.73” x 2.68” |
---|---|
Weight” | 2.30 LBS |
Jack Contact Material: Solid Nickel Silver
12340 World Trade Drive, San Diego, CA 92128
619-487-1600
800-854-2235
www.carvin.com
https://manual-hub.com/
References
- Carvin Audio Great Sounding Gear For Musicians and Sound Professionals
- Manual-Hub.com – Free PDF manuals!