Conrad 2522809 E0217 Thermometer User Manual

Conrad 2522809 E0217 Thermometer

Item no. 2522809

Intended use
This product is designed to measure the temperature in degrees Celsius (°C) or Fahrenheit (°F). The temperature is displayed on the built-in LCD display. The temperature unit can be changed. The maximum and minimum temperatures for each day are saved and can be displayed.
It is intended for indoor use only. Do not use it outdoors. Contact with moisture, e.g. in bathrooms, must be avoided under all circumstances.
For safety and approval purposes, you must not rebuild and/or modify this product. If you use the product for purposes other than those described above, the product may be damaged. In addition, improper use can cause hazards such as short-circuiting, fire, electric shock etc. Read the instructions carefully and keep them. Make this product available to third parties only together with its operating instructions.

This product complies with the statutory national and European requirements. All company names and product names are trademarks of their respective owners. All rights reserved.

Delivery content

• Thermometer
• Button cell CR2025 (pre-installed)
• Operating instructions

Up-to-date Operating Instructions
Download the latest operating instructions at www.conrad.com/downloads or scan the QR code above. Follow the instructions on the website.

Safety instructions

Read the operating instructions carefully and especially observe the safety information. If you do not follow the safety instructions and information on proper handling in this manual, we assume no liability for any resulting personal injury or damage to property. Such cases will invalidate the warranty/guarantee.

General information

• The device is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. This may become dangerous playing material for children.
• Protect the product from extreme temperatures, direct sunlight, strong jolts, high humidity, moisture, flammable gases, vapours and solvents.
• Do not place the product under any mechanical stress.
• If it is no longer possible to operate the product safely, take it out of operation and protect it from any accidental use. Safe operation can no longer be guaranteed if the product:
  • is visibly damaged,
  • is no longer working properly,
  • has been stored for extended periods in poor ambient conditions or
  • has been subjected to any serious transport-related stresses.
• Please handle the product carefully. Jolts, impacts or a fall even from a low height can damage the product.
• Also observe the safety and operating instructions of any other devices which are connected to the product.
• Consult an expert when in doubt about operation, safety or connection of the device.
• Maintenance, modifications and repairs are to be performed exclusively by an expert or at a qualified shop.
• If you have questions which remain unanswered by these operating instructions, contact our technical support service or other technical personnel.

Battery

• Correct polarity must be observed while inserting the battery.
• The battery should be removed from the device if it is not used for a long period of time to avoid damage through leaking. Leaking or damaged batteries might cause acid burns when in contact with skin, therefore use suitable protective gloves to handle corrupted batteries.
• Batteries must be kept out of the reach of children. Do not leave batteries lying around, as there is a risk that children or pets may swallow them.
• Batteries must not be dismantled, short-circuited or thrown into fire. Never recharge non-rechargeable batteries. There is a risk of explosion!

Operating elements

1. °C / °F button
2. MAX MIN button
3. Stand/hanger
4. Battery compartment (removable)

Display symbols

MIN symbol / MAX symbol

Temperature unit symbol

Battery symbol

Frost symbol (Displays if the temperature is between +4 °C and +7.9 °C)

Thermometer symbol

Operation

Activating and changing the battery

• A button cell battery has been installed in the battery compartment by factory default. Before first time use, remove the protective plastic strip from the battery compartment. The protective strip prevents battery discharge.
• Replace the battery once the display starts to weaken significantly or turns off completely. Proceed as follows to insert a battery:
• Remove the battery compartment (4) on the bottom of the thermometer (observe the arrow markings).
• Insert a 3 V CR2025 button cell (included) with correct polarity into the battery compartment (observe plus/+ and minus/-).
• Slide the battery compartment with the newly inserted battery back into the thermometer in the correct position. Ensure that it clicks into place properly.
  When changing/inserting the battery, also refer to the diagram on the back of the product.

Mounting the product

• Pull the stand (3) outwards. Place the product on a horizontal, stable and sufficiently large surface using the stand. Use suitable padding to protect the surfaces of valuable furniture against scratches.
• Push the stand (3) upwards to use it as a hanger. Hang the product in a suitable location in your fridge, or secure it to a ferromagnetic surface using the magnet.

Operation

Displaying the temperature

• After inserting the battery, all display symbols will appear briefly on the LCD display.
• The current temperature will be displayed.
• To select the temperature unit, press the °C / °F button (1). The unit changes.
• Press the button again to go back to the initial setting. You can choose between Celsius and Fahrenheit for the temperature display.
• HH.H is displayed if the measured temperature exceeds +60 °C.
• LL.L is displayed if the measured temperature drops below -20 °C.

Displaying and deleting max/min values

• Press the MAX MIN button (2) to display the maximum and minimum temperature values. Press once to display the maximum recorded temperature or twice to display the minimum recorded temperature. Press three times to go back to the current temperature.
• The MIN and MAX symbols are displayed together with the values.
• The thermometer automatically switches back to the current temperature after 10 seconds.
• Press and hold the MAX MIN button (2) for 2 seconds to delete the maximum and minimum temperature values.
• Removing and replacing the battery also deletes the saved values and clears the product memory.

Care and cleaning

• Under no circumstances should you service any of the components in the interior of the product, therefore never open/dismantle it. The device does not require maintenance except for occasional cleaning.
• Remove the battery before cleaning the product.
• Never use aggressive detergents, rubbing alcohol or other chemical solutions, as these could damage the casing or even impair the functioning of the product.
• Use a dry, lint-free cloth to clean the product. Do not press too hard on the surface when cleaning to avoid scratch marks.
• Dust can be easily removed using a clean long-haired brush.

Disposal

Product

This symbol must appear on any electrical and electronic equipment placed on the EU market. This symbol indicates that this device should not be disposed of as unsorted municipal waste at the end of its service life.

Owners of WEEE (Waste from Electrical and Electronic Equipment) shall dispose of it separately from unsorted municipal waste. Spent batteries and accumulators, which are not enclosed by the WEEE, as well as lamps that can be removed from the WEEE in a non-destructive manner, must be removed by end users from the WEEE in a non-destructive manner before it is handed over to a collection point.

Distributors of electrical and electronic equipment are legally obliged to provide free take-back of waste. Conrad provides the following return options free of charge (more details on our website):

• in our Conrad offices
• at the Conrad collection points
• at the collection points of public waste management authorities or the collection points set up by manufacturers or distributors within the meaning of the ElektroG

End users are responsible for deleting personal data from the WEEE to be disposed of.
It should be noted that different obligations about the return or recycling of WEEE may apply in countries outside of Germany.

(Rechargeable) batteries
Remove batteries/rechargeable batteries, if any, and dispose of them separately from the product. According to the Battery Directive, end users are legally obliged to return all spent batteries/rechargeable batteries; they must not be disposed of in the normal household waste.

Batteries/rechargeable batteries containing hazardous substances are labelled with this symbol to indicate that disposal in household waste is forbidden. The abbreviations for heavy metals in batteries are: Cd = Cadmium, Hg = Mercury, Pb = Lead (name on (rechargeable) batteries, e.g. below the trash icon on the left).

Used (rechargeable) batteries can be returned to collection points in your municipality, our stores or wherever (rechargeable) batteries are sold. You thus fulfil your statutory obligations and contribute to environmental protection.
Batteries/rechargeable batteries that are disposed of should be protected against short circuit and their exposed terminals should be covered completely with insulating tape before disposal. Even empty batteries/rechargeable batteries can contain residual energy that may cause them to swell, burst, catch fire or explode in the event of a short circuit.

Technical data

• Power supply …………………………………. 1 x 3 V/DC CR2025 battery (included)
• Battery life ……………………………………… About 12 months
• Temperature range …………………………. -20 to +60 °C
• Accuracy ……………………………………….. ±1 °C (from -20 to +60 °C)
• Operating/storage conditions ……………. -20 to +60 °C, 20 – 90 % RH
• Dimensions (W x H x D) ………………….. 71 x 24 x 45 mm
• Weight ………………………………………….. 31 g (without battery)

This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com). All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication represents the technical status at the time of printing.

Copyright 2022 by Conrad Electronic SE.
*2522809_v2_1122_02_dm_mh_en

References

• Conrad Electronic » All parts of success
• Download center

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>