VIMAR EIKON 20292.CC USB C+C Power Supply 5V 3A 1M Gray Instructions
- June 9, 2024
- VIMAR
Table of Contents
VIMAR EIKON 20292.CC USB C+C Power Supply 5V 3A 1M Gray
5 V 3 A USB power supply unit for electronic devices, 2 USB type C outputs which provide altogether 3 A, optimised to charge two devices simulta-neously (e.g. tablet, smartphone), 120-240 V~ 50/60 Hz power supply.
The device should be used to charge mobile phones and all electronic devices that can be charged from any standard USB type C socket outlet.
- Read the instructions before installation and/or use.
FEATURES
- Power supply: 120-240 V~ 50/60 Hz
- Power consumption: 280 mA at 120 V~ and 170 mA at 240 V~
- Output voltage: 5.0 V d.c. (± 5%) ES1 and/or SELV
- Max output load: 3 A
- Output power: 15.0 W
- Average efficiency in active mode: 83%
- The efficiency with low load (10%): 81%
- Power with no load: 0.03 W
- Protection degree: IP20
- Operating temperature: 0°C to +35°C (indoor use)
- The device in class II
- Installation for CAT III overvoltage category
OPERATION
Type C fast charge outputs are designed to charge more powerful devices at high speed as well by providing up to 3 A on each individual output (they are therefore available up to 15 W). The power supply unit, which is equipped with two USB outputs, is optimized to charge one device up to 3 A (e.g. tablet or PC) or two devices simultaneously provided their total absorption does not exceed 3 A (e.g. smartphones). Always check the data plate on the device you are charging.
The following table contains some examples and possible combinations:
INSTALLATION RULES
Installation must be carried out by qualified persons in compliance with the current regulations regarding the installation of electrical equipment in the country where the products are installed. The device can be installed in a flush mounting box or surface mounting box and completed with Linea, Eikon, Arké, or Plana cover plates in dust-free places, protected from accidental impacts and away from heat sources.
IMPORTANT
- An easily accessible omnipolar disconnection switch with a contact gap of at least 3 mm must be installed upstream from the power supply.
- Install the device at a height of no more than 2 m.
- The length of the connection cable to the electronic device must be no more than 3 m.
- The power supply unit is protected internally against overloads.
- Cable stripping 6 mm .
REGULATORY COMPLIANCE
LV Directive. EMC directive. RoHS directive. ErP directive.
Standards EN IEC 62368-1, EN 55032, EN 55035, EN IEC 61000-3-2, EN 61000-3-3,
EN 50563, EN IEC 63000.
(EU) Regulation for external power supply unit no. 2019/1782.
REACH (EU) Regulation no. 1907/2006 – Art.33. The product may contain traces
of lead.
WEEE – Information for users
If the crossed-out bin symbol appears on the equipment or packaging, this
means the product must not be included with other general waste at the end of
its working life. The user must take the worn product to a sorted waste
center, or return it to the retailer when purchasing a new one. Products for
disposal can be consigned free of charge (without any new purchase obligation)
to retailers with a sales area of at least 400 m2 if they measure less than 25
cm. An efficient sorted waste collection for the environmentally friendly
disposal of the used device, or its subsequent recycling, helps avoid the
potential negative effects on the environment and people’s health and
encourages the re-use and/or recycling of the construction materials.
Viale Vicenza
14 36063 Marostica VI – Italy www.vimar.com.