luminii LLDW68WET LineLED Wet 24V Warm Dim LED Strip Instruction Manual
- June 9, 2024
- luminii
Table of Contents
luminii LLDW68WET LineLED Wet 24V Warm Dim LED Strip
LineLED Wet 24V –
Installation Instructions
Models LLDW68WET-T
Please read all instructions prior to installation and keep for future reference!
- PRODUCT SHOULD BE INSTALLED BY A QUALIFIED ELECTRICIAN
- ENSURE POWER IS OFF AT FUSE BOX PRIOR TO INSTALLATION TO PREVENT ELECTRICAL SHOCK
- USE ONLY WITH CLASS 2 POWER UNIT
- SUITABLE FOR WET LOCATIONS
- FOR UNDER-CABINET OR SHELF MOUNT
- AVOID EXPOSURE TO DIRECT SUNLIGHT
- NOT SUITABLE FOR APPLICATIONS WHERE LEDS CAN BECOME SUBMERGED
REV0.2
02242022
1 / 1
7777 Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
info@luminii.com
www.luminii.com
-
Remove the paper backing from the LineLED and firmly press down making sure there are no air bubbles that can cause surface irregularities to the LineLED. Do not remove the adhesive, removing the adhesive may cause arcing of the Line LED tape.
NOTE – Avoid bending the
LineLED in sharp horizontal angles which may damage the LEDs
NOTE – When removing backing &
laying LineLED to surface avoid ripples on LineLED. -
Install clip, part number CL -2, every 12.00” to secure LineLED Wet to mounting surface.
-
If installing LineLED Wet inside an extrusion that is facing up, drainage holes should be drilled along the inner corner of the extrusion at every 12”. Drill 1/16” to 1/8” diameter holes before installing LineLED Wet. Also, silicone should be applied to edges of the endcaps and lens before installing onto extrusion.
-
Always ensure power to power supply is off!
Follow diagram below to connect power feed wires to power supply. Refer to power supply instructions for wiring line voltage side.
Connect positive red wire to RED low
voltage wire from power supply. Also, connect negative black wire to PURPLE
low voltage wire from power supply.
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE