luminii LLDW60X2 LineLED 24V LED Strip Lights Instruction Manual
- June 9, 2024
- luminii
Table of Contents
LineLED 24V – Installation Instructions
Models LLDW60X2-
LLDW60X2 LineLED 24V LED Strip Lights
Please read all instructions prior to installation and keep for future reference!
- Product should be installed by a qualified electrician.
- Prior to installation ensure power is off at fuse box to prevent electrical shock.
- Use only with Class 2 power unit. Utiliser seulement avec Classe 2 unite d’alimentation electrique.
- Suitable for Damp Locations. Convient Aux Emplacements Humides.
- For under-cabinet or shelf mount.
Attention: Always test LineLED operation before installing.
Connect LineLED to power supply to ensure it is working properly and no damage
has occured during shipping.
-
Clean the area thoroughly where the LineLED will be installed.
Remove the paper backing from the LineLED and firmly press down making surethere are no air bubbles that can cause surface irregularities. Do not remove theadhesive, removing the adhesive may cause arcing of the Line LED tape. -
If length of LineLED needs to be adjusted on site, simply cut the LED strip in between solder pads. Always cut from end with no wire leads.
-
Always ensure power to power supply is off! Follow diagrams on page 2 to connect power feed wires to power supply.
Wiring Diagrams
Using DMX LED power supply
Using non dimming LED power supply, receiver and controller
Operations to Controller
- Press the learning key on the receiver, then push the rotary button. Once successfully learn, the LED lights will blink on the receiver. Do the same for the other receivers if you use them, you can add as many optional receivers as you want.
- Short press once the rotary button to switch on/off. Adjust dim brightness by the rotary button from left to right 0.1 – 100%. Adjust dim brightness by the rotary button from right to left 0.1 – 100%. Long press rotary button, the light will be 100% brightness
Double click rotary button, it will enter into dimming color temperature mode, dim WW & CW associatively, for example if WW is 70%, CW is 30%. Double click again, will enter into dimming brightness mode.
DDW-MC
Wireless Controller
Using warm dim LED power supply
Using tunable white LED power supply
Using non dimming LED power supply, decoder and controller
Using non dimming LED power supply and decoder
7777 Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
info@luminii.com
www.luminii.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>