JL AUDIO MMR-11W Wireless NMEA 2000 Remote Controller for MediaMaster Owner’s Manual
- June 9, 2024
- JL AUDIO
Table of Contents
MMR-11W Wireless NMEA 2000 Remote Controller for MediaMaster
_1 1
~
MMR-llW / MMR-11W-N2K
Wireless, NMEA 2000 Controller for MediaMaster®
i@ x1 x1
x2
0,,,,.-,
x2
ll<U•01156S 072921
i-x1
•MMR-11W·N2Ksl”Own
1111111111111111111111 IIIII IIIII IIII IIII
–1 I MMR-11W_MAN–Oe2621.lndd 2-4
IMPORTANT
• Installation requires appropriate tools and safety equipment.
Profess·o,al ·nstallaro, ·s recommerded.
• This product is wate·-resistanc. Do no: sJb’Tlerge or sJb;eci
to high-pressure water sp•ay.
, Be’o’e installation, turn off the aJdio system and d’sconnect
the banery system from the audio system.
• Be’o’e cutting or dr’lling, chec< for potent’a oostacles
tehind mounting sur’aces.
• Do not mount this produce in an engine compartr1ent or
o:he• a’ea of extreme rea1.
• Mount this product securely to prevent da’Tlage O’ injury
in seve’e co,o·rons.
FCC COMPLIANCE STATEMENT
Th s device comp I es w :h Part IS of the FCC Rules Cperatlon Is subject to
ire
following two condlt,ors: (1) this cevlce May no: cai…se harmfu1 nter’erence,
and
(2) thiS oevlce 1’1″‘USt not accept any Interference received, lrcli.,clng
lnte-rfere-rce- that n–ay
cavse urdeslre-d opera:lon.These limits a,e des gneo to provide reasonab e
protection
agalrst harmful Interference n a re-s’der.tlal lnsta lat’on,
ThiS equ’pment generates, uses and car. radiate raolo freql.e-rc:,o energy
and, f not
lristal ed In ac::ordance with the ‘rsm,ctlons, may cause harmful Interference
to rad o
com!T’un:cat-ors. However, the’e -s ro guarantee ti-.at lnterfererce will net
occur In a
partlcLolar lnstallatlon. If this equlpmerit does cause harmful nter’erence to
radio er
tele..,ls on re-ceptlcn, tt-e user Is ercouraged to tty to correct the mer-
Ference by one er
mo 1e of tt–e follewl ng measures:
– Reer’ent or 1e!ceate tt-e re-celvlrgantenna.
– lrcrease separation berween the equ p!T’ent and the 1ece … er.
-Co”lnect the equipment to an outlet on a circuit d fferent from that to which tt–e
re-cei … er s connected
-CO”lsult the c’-ealer or an experienced radio/Tl/ techn:.Clal”I for help.
Any ct–anges or IT’OOiflcatlons rct expressly approved by the pany ,espotslble
fer
compllanee could void the usefs authorlt>· cooperate thlsequtpmerit
GENERAL CONTROL FUNCTIONS
0 • Long press to turn the source unit ON/OFF
SRC • Short press to advance through available sources
►II • Short press to mute/unmute or p,3use/resume audio
Miif!
+ • Short press to increase volume
VOL • Long press to increase volume rapidly
VOL • Short press to decrease volume – • Long press to decrease volume rapidly
►►I • Short press to select the next tra ck or stored Favorite
• Long press to fast-forward audio
I◄◄
• Short press to restart t rack/select the previous track
or stored Favorite
• Long press to fast-rewind audio
“Some contr-J functions w · I varyde;::ending on the source un ‘t aad selected
soui:e.
LED SIGNAL CONFIRMATION
Tre MM8-· 1W trans’1″itte• is eqJipped with a green LED r1ounted (‘) ► II .
betwee1 ,he.,;; and “”‘ buttons. When a~y buttcn ,s pressed, the LED
will fiash co repo’t tne status condit’o,s below.
Rapid Flashing I Signal sent and received successfully
Signal sent but not received successfully
One Short Flash I Possible causes: out of operating range, low battery level
or the receiver is not active (not powered}
RECEIVER MODULE PROGRAMMING
Not e: The transmitter and receiver included with the MMR-11 W
system are already paired.
Up co twenty (20) MM8-‘ 1W Remotetransr1itters r1aybepairec toa
single receiver modu e.
To Pair A New Transmitter (Required for MMR-11 W-Remote)
I. D’sconnec1 + 12V power from yoJr MediaMas:er” by removing the
5-amp fuse from its fuse ro oe·, unp,ugging its 4-pin power p vg,
or switching off its + 12V supply circv·t.
2. Recor,ecc + 12V powe-to yoJr MediafVas:er•, then immediately
press and rod both ►►I arc I◄◄ buttons 01 :he transm·tter.
3. Continue holdirg both ►►I arc I◄◄ bunons for 5 secoros, then
release bo1h buno,s.
, If successful. tne status LED w·’ fiash rapidly with any bu1ton press.
, If unsJccessful, :he s:atus LED will em:1 one scort f asc with any
button press.
4. Repeat s;eps 1 to 3 to pa·r add’tional transmitters (up to ten total).
Note:This procedure must be complet ed within 15 seconds aft er
reconnecting +12V power (step 2).
In case o’ m·splaceo transmitters, yoJ may de ete all remotes ‘rom tre
rece’ver module’s memory, Note: All paired t ransmitters will stop
working after deletion. Subsequent remote cont rol funct ional ity will
require each transmitter to be paired with the receiver.
To Delete All Transmitt ers
I. D’sconnect + 12V power from yoJr MediaMas:er” by removing the
5-amp fuse from its fuse ro ce·, unp,ugging its 4-pin power p vg,
or switching off its + 12V supply circu 1.
2. Recor,ect + 12V powe- to yoJr MediaMas:er•, then immediately
press and ro o both v6L and V~L buc:ons on an
existing (paired) transmitter.
3. Continue holdirg both vbL and v~L buttons fo, 5 seconds, then
release both butto,s.
• If successful, tne status LED w” emit o,e sho·i fiash wth ary
button press arc the t rarsminerwill no longer co1trol your
MediaMaster•.
, If unsJccessful, :he s:atus LED will f asc rap·d y with any buc:on
press and ere trans,n;ner w” still co,crol your MediaMaster•.
Note:This procedure must be complet ed within 15 seconds after
reconnecting +12V power (step 2).
1 1_
8126121 5:16 PM I
_11
MMR-11 W CONNECTION
“o~
MMR-11 W-N2K CONNECTION
To applicable
network
components
(not shown)
o.
–1 I MMR-11WMAN-Oe2621.lndd ~
~o~
pj
‘o”
.o
01
NMEA.. . connector
of MediaMasterC’
MediaMaster·
SOURCE UNIT
MedlaMaster·
To a pplicable
,, network
~ components
(not shown)
REMOTE BASE MOUNTING OPTIONS
Panel Mount
Pipe/Tube Mount
Steering Wheel Mount
Operating Frequency I 2.4 GHz
Operating Range* I Up to lSOft.(45 m)
Operating Temperature I -4 °F to+ 167 °F (-20 °c to +75 °( )
Fuse Value I 2 A (MMR-11W only)
NMEA 2000· LEN I 2
IP Rating (Transmitter) I IP67
IP Rating (Receiver) I IP65
Transmitter Battery Type I CR2032
Dimensions 1 2.99 in x 2 in x 1.07 in
(Transmitter) 76 mm x 50.8 mm x 27.2 mm
Dimensions 1 4.02 in x 3.01 in x 1.42 in
(Receiver) 102.1 mmx76.S mmx36.1 mm
• Maxlrrum cperat ng ~ngew11:val)’ bils-edon nstallaton
spec :’,cs and transmitter battery level
2-Year Limited Warranty (U.S.A.)
Visit www.jlaudio.com for warranty details.
For Service Information in the U.SA. please contact:
JL Audio Custome’ Service: (954) 443.1·00 (9:COAM • 5:00 PM EST)
JL Audio Technical Support: www.jla”dio.com/support
International Warranties:
Prooucts pucraseo outs”oe tre Uniteo States of America arecove•ed
only by trat cour.;ry’s oistrbutor a10 not by JL Audio, Ire.
,,_
8126121 5:16 PM I