LUTRON MA-R/MSC-AD 600-Watt Multi Location Accessory Dimmer Installation Guide
- June 9, 2024
- Lutron
Table of Contents
- LUTRON MA-R/MSC-AD 600-Watt Multi Location Accessory Dimmer
- Quick Install Guide
- Maestro Companion Device
- Important Notes
- Disconnect Power
- 3-Way Wiring with MACL-153M Dimmer
- 4-Way Wiring with MACL-153M Dimmer
- Operation
- Troubleshooting
- Limited Warranty
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
LUTRON MA-R/MSC-AD 600-Watt Multi Location Accessory Dimmer
Quick Install Guide
MA-R / MSC-AD 8.3 A
Does not work alone. Must be used with a Maestro dimmer. If using anything
other than a MACL-153M, please see the installation guide for that dimmer.
Please read before installing
Maestro Companion Device
How-to videos
Important Notes
- Install in accordance with all national and local electrical codes.
- When no “grounding means” exists in wallbox, the National Electrical Code (NEC®) allows a control to be installed as a replacement when a plastic faceplate with plastic fasteners is used, or the circuit is protected by a ground fault circuit interrupter (GFCI). Lutron wallplates meet this requirement. Cap or remove green wire before screwing control into wallbox.
- Protect the control from dust and dirt when painting or spackling the wall.
- Clean the companion device with a soft damp cloth only. Do not use any chemical cleaners. For more information, please see www.lutron.com/cleaning
- For indoor use only.
- For any 3-way / 4-way circuit, use only one Maestro dimmer (MACL-153M) with up to 9 companion devices.
- Maximum wire length between the main control and the farthest accessory switch is 150 ft (45 m).
Disconnect Power
WARNING: SHOCK HAZARD. May result in Serious Injury or Death. Turn off power at circuit breaker or fuse before installing.
3-Way Wiring with MACL-153M Dimmer
IMPORTANT: Before disconnecting the existing devices, tag the wire
connected to the different colored screw (typically black, but wire colors
vary, and labeled COM). This is the Common wire.
QUESTIONS? See www.lutron.com/MAC
4-Way Wiring with MACL-153M Dimmer
NOTE: Before disconnecting wires of existing devices, please tag wires as described above for 3-way wiring.
Operation
IF LIGHTS ARE OFF: Single tap T for preset. Double tap T for full brightness.
IF LIGHTS ARE ON: Double tap T for full brightness. Single tap T to turn off. Press and hold T for delayed fade-to-off.
Troubleshooting
For more information, please visit www.lutron.com/MACL
Limited Warranty
www.lutron.com
TechnicalDocumentLibrary
369-119_Wallbox_Warranty.pdf ©2022 Lutron Electronics Co.,
Inc. Lutron and Maestro are trademarks or registered trademarks of Lutron
Electronics Co.,
Inc., in the U.S. and other countries.
The YouTube icon is a trademark of Google LLC.
24/7
Support: 1.844.LUTRON1 (USA / Canada)
+1.888.235.2910 (Mexico)
www.lutron.com/MACL
References
- Products Cleaning Recommendation | Lutron
- Help links for installation & purchasing Maestro C.L dimmers
- How to Install a Dimmer Switch | Dimmer Switch Wiring | Lutron Web Tools
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>