LUTRON Claro Smart Switch for Caseta Smart Lighting Instruction Manual
- June 3, 2024
- Lutron
Table of Contents
LUTRON Claro Smart Switch for Caseta Smart Lighting
DVRF-AS 120 V~ 50 / 60 Hz 6 A
ONLY for use with:
- Diva smart dimmer model number: DVRF-6L
- Claro smart switch model number: DVRF-5NS
How-to videos
Important Notes
- Install in accordance with all national and local electrical codes. When no “grounding means” exists in wallbox, the National Electrical Code (NEC®) allows a control to be installed as a replacement when a plastic faceplate with plastic fasteners is used, or the circuit is protected by a ground fault circuit interrupter (GFCI). Lutron wallplates meet this requirement. Cap or remove green wire before screwing control into wallbox.
- Protect the control from dust and dirt when painting or spackling the wall.
- Clean the accessory switch with a soft damp cloth only. Do not use any chemical cleaners. For more information, please see www.lutron.com/cleaning
- For indoor use only.
- For 3-way or multi-location wiring, use only one Diva smart dimmer (DVRF-6L) or Claro smart switch (DVRF-5NS) with up to 10 accessory switches.
- Maximum wire length between the main control and the farthest accessory switch is 150 ft (45 m).
Disconnect Power
WARNING: SHOCK HAZARD. May result in Serious Injury or Death. Turn off power at circuit breaker or fuse before installing.
3-Way Wiring with a Dimmer
IMPORTANT : Before disconnecting the existing devices, tag the wire connected to the different colored screw (typically black, but wire colors vary, and labeled COM). This is the Common wire. QUESTIONS? See www.casetawireless.com/support
- NOTE : Ensure that the same wire connects to the blue wire at all locations.
- NOTE : Main dimmer can be placed in any location.
- NOTE : When using an accessory switch with a dimmer the black and red wires are reversible
3-Way Wiring with a Switch
- NOTE : Ensure that the same wire connects to the blue wire at all locations.
- NOTE : Main switch can be placed in any location.
- NOTE : The black wire of the main switch must always connect or point towards line.
See www.casetawireless.com/3way for more details.
4-Way Wiring with a Dimmer
IMPORTANT: Before disconnecting the existing devices, tag the wire connected to the different colored screw (typically black, but wire colors vary, and labeled COM). This is the Common wire. QUESTIONS? See www.casetawireless.com/support
4-Way Wiring with a Switch
- NOTE : Ensure that the same wire connects to the blue wire at all locations.
- NOTE : Main switch can be placed in any location.
- NOTE: The black wire of the main switch must always connect or point towards line.
See www.casetawireless.com/3way for more details
Operation
Accessory Switch with a Dimmer
- Single tap the ON button for On (to the preset level).
- Double tap the ON button for full brightness.
- Single tap the OFF button for Off.
- Press and hold the OFF button (1 second) for 30 second delayed fade-to-off.
Accessory Switch with a Switch
- Single tap the ON button for On.
- Single tap the OFF button for Off.
- Press and hold the OFF button (1 second) for 30 second delayed off.
Troubleshooting
| Symptom | Possible Cause |
|---|---|
| The load does not turn ON or no LEDs on the dimmer or switch turn ON. | • Front |
Accessible Service Switch (FASS) on the main dimmer or switch is pulled out to the OFF position.
• Light bulb(s) burned out.
• Breaker is OFF or tripped.
• Wiring error. Refer to the wiring diagrams above or go to www.lutron.com/wiringwizard
The load turns ON and the main dimmer or switch works, but accessory switch
does not work.| • Wire connected to the blue wire on the main dimmer or main
switch is not the same wire connected to the blue wire of the accessory
switch.
The load does not remain ON and main dimmer or switch LEDs glow dimly or
blink.| • Blue wire is miswired to neutral wire or touching ground.
For more information, please visit www.casetawireless.com/support
Limited Warranty
www.lutron.com/TechnicalDocumentLibrary/369-119_Wallbox_Warranty.pdf ©2022 Lutron Electronics Co., Inc. Lutron, Diva, Caséta, Claro, and LED+ are trademarks or registered trademarks of Lutron Electronics Co., Inc., in the U.S. and other countries
24/7 Support: 1.844.LUTRON1 (USA / Canada) +1.888.235.2910 (Mexico) www.casetawireless.com/support
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>