LUTRON 0302062 Maestro LED Dimmer Installation Guide

LUTRON 0302062 Maestro LED Dimmer Installation Guide

How-to videos

lutron.com/MACL

Install with confidence

Use included diagrams or visit our website for step-by-step instructions.

Find the right LED

lutron.com/LEDfinder

Included Parts

Ganging and Derating

Remove side sections if mounting two or more devices side by side (see chart for new wattage rating).

Note: Derating not necessary for LED/CFL loads.

Important Notes

1. CAUTION: Use only with permanently installed fixtures with dimmable screw-in compact fluorescent, dimmable LED, halogen, or incandescent lamps. To avoid overheating and possible damage to other equipment, do not use to control receptacles, motordriven appliances, or transformer-supplied appliances.
2. Install in accordance with all national and local electrical codes. When no “grounding means” exists in wallbox, the National Electrical Code (NEC®) allows a control to be installed as a replacement when a plastic faceplate with plastic fasteners is used, or the circuit is protected by a ground fault circuit interrupter (GFCI). Lutron wall plates meet this requirement. Cap or remove green wire before screwing control into wallbox.
3.  Protect the dimmer from dust and dirt when painting or spackling the wall.
4. It is normal for the dimmer to feel warm to the touch during operation.
5. Clean the dimmer with a soft damp cloth only. Do not use any chemical cleaners. For more information, please see lutron.com/cleaning
6. For indoor use only

INSTALL WITH CONFIDENCE

WARNING: SHOCK HAZARD.
May result in serious injury or death. Turn off power at circuit breaker or fuse before installing.

Wiring Option 1: Single Pole

For lights switched from one location:

NOTE: Black wires are interchangeable.

Wiring Option 2: 3-Way / 4-Way with Companion Dimmer(s)

For lights switched from two or more locations: See Maestro Companion Dimmer Installation Guide (Model MA-R or MSC-AD) for details

Wiring Option 3: 3-Way with an Existing Switch

For lights switched from two locations

IMPORTANT: Mark or tag the common wire on both switches before removing the old switch. We recommend visiting lutron.com/MACL to properly complete all three steps.

1. Install the dimmer
   
   

2. Rewire the existing switch
   Location 2
   

3. Reprogram the dimmer

• Hold the Tapswitch ( T ) and the Raise button ( R ) until an indicator light starts blinking.
• Use the Lower button ( L ) to bring blinking LED to the bottom.
• Hit the Tapswitch ( T ) to save.

AFTER INSTALLATION: Adjust dimming range for LEDs and CFLs

1. Hold T & L until an indicator light (IL) blinks on the MACL dimmer.

2. Use or to improve lowest dimming level. Turn lights off and on at lowest level to confirm operation.

Adjust Settings

Visit
www.lutron.com/MACL

Operation

IF LIGHTS ARE OFF: Single tap T for preset. Double tap T for full brightness. IF LIGHTS ARE ON: Double tap T for full brightness. Single tap T to turn off. Press and hold T for delayed fade-to-off.

Troubleshooting

Light have poor dimming
performance| Adjust low-end trim
Find best performing bulbs at
www.lutron.com/LEDFinder

For more information, please visit
www.lutron.com/MACL

Limited Warranty: www.lutron.com/TechnicalDocumentLibrary/369-119_Wallbox_Warranty.pdf ©2022 Lutron Electronics Co., Inc.
Lutron, Maestro, and LED+ are trademarks or registered trademarks of Lutron Electronics Co., Inc., in the U.S. and other countries. The YouTube icon is a trademark of Google LLC.

P/N 0302062 REV A

Receive an Extended Warranty: www.lutron.com/CLregistration
Customer Assistance: 1.844.LUTRON1 (USA/Canada) +1.888.235.2910 (Mexico)

References

• Products Cleaning Recommendation | Lutron
• LED Compatibility Tool | Lutron
• Help links for installation & purchasing Maestro C.L dimmers
• Products Cleaning Recommendation | Lutron
• lutron.com/CLregistration
• LED Compatibility Tool | Lutron
• Help links for installation & purchasing Maestro C.L dimmers

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>