Alphacool Core M.2 NVMe PCIe 4.0 Liquid Cooler User Guide
- June 9, 2024
- ALPHACOOL
Table of Contents
Alphacool Core M.2 NVMe PCIe 4.0 Liquid Cooler User Guide
Read the safety instructions before starting the installation.
Safety instruction
Accessories
Place the pads on the SSD
If the SSD has memory chips on both sides, use the 1 mm thermal pad on the top and the 0.5 mm pad on the bottom side of the SSD. If the memory chips are only on the top side, use the 1 mm thermal pad on the top and 1 mm + 0.5 mm pad on the bottom side of the SSD.
Mounting the SSD & cooler
Once the thermal pads are installed on the SSD, secure the SSD to the PCB with the nut and M3x4 screw as shown. Place the 1 mm pad under the PCB and attach the cooling block to the PCB and backplate with 4 x M2x5 as shown in the drawing.
LED connection
To control the digital – RGB lighting, connect the included adapter to the 3 – pin female connector and plug it to a digital – RGB controller (e.g. Alphacool Aurora Eiscontrol, Art.: 15360, not included). You can connect additional digital – RGB LEDs to the remaining 3 – pin male connector.
Alphacool International GmbH
Marienberger Str. 1
D-38122 Braunschweig
Germany
Support: +49 (0) 531 28874 – 0
Fax: +49 (0) 531 28874 – 22
E-mail: info@alphacool.com
https://www.alphacool.com
V.1.00-03.2022
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>