HYUNDAI 68711 Turbo Oil Radiator User Manual
- June 8, 2024
- HYUNDAI
Table of Contents
HYUNDAI 68711 Turbo Oil Radiator
DESCRIPTION
- On/Off Switch
- Thermostat knob
- Handle
- Oil Filled Ribs
- Turbo Fan
- Turbo Switch
- Cord Storage
- Wheels
Package contents
- Radiator heater
- Castor brackets
- U-bolts
- Wing nuts
- Instruction manual
- Warranty and service conditions
ASSEMBLY
- Place the heater upside down on a cloth to prevent damage.
- Install one of the two supplied U-bolts into the caster bracket (fig. B).
- Place the caster bracket between the two outer ribs and slide the U-bolt through the centre (fig. C). Repeat on the other side.
- Turn the U-bolt a quarter turn so that the straight threaded end is vertically pointing in the air (fig D).
- Make sure the casters are horizontally aligned and tighten the wing nuts securely (fig. E). These can be tightened without tools.
OPERATION
- Connect the device to an earthed socket.
- Turn the on/off switch (1) to position I, II or III.
- Turn the thermostat knob (2) clockwise until the maximum is reached.
- When the desired temperature has been reached in the room, slowly turn the thermostat knob counter clockwise until you hear a click. After this, the heater will stop working.
- The heating switches on and off automatically to maintain the set room temperature.
- Turn the thermostat knob (2) to the minimum position to switch off the heater.
- Turn the on/off switch (1) to position 0.
- Then disconnect the device.
Turbo fan
This model is equipped with a heating fan that works separately and helps to heat up the room faster.
- Press the turbo switch (6) to enable this function.
Overheating protection
The heater is equipped with a safety device to switch off in the event of overheating. If this protection has turned off the heater, turn the thermostat knob to the “0” position, press the on/off switch to position 0 and remove the plug from the socket. Let the heater cool down completely. Inspect and clear the air inlet or outlet for covering or obstruction. Then try to restart the heater. If the problem persists, return the heater to the nearest service facility for examination or repair.
CLEANING
Regular cleaning extends the life of the device.
- Clean the housing with a soft cloth or soft paper. If dirt is difficult to remove, use a soft cloth with a little soapy water.
- Use a vacuum cleaner to vacuum dust and lint from the grille.
- Never try to clean the inside of the heater.
- Store the device in a cool, dry place.
Do not use chemical cleaners, gasoline or other solvents. These can irreparably damage the housing.
Always remove the plug from the socket and let the heater cool down completely before cleaning or performing maintenance.
TECHNICAL DATA
- Mains voltage Vac 230
- Mains frequency Hz 50
- Power input W 2500
- Weight kg 10.5
GUARANTEE
Refer to the enclosed guarantee conditions for the terms and conditions of guarantee.
ENVIRONMENT
Your product, accessories and packaging should be sorted for
environmentalfriendly recycling.
Only for EC countries
Do not dispose of power tools into domestic waste. According to the European
Guideline 2002/96/EC for Waste Electrical and Electronic Equipment and its
implementation into national right, power tools that are no longer usable must
be collected separately and disposed of in an environmentally friendly way.
Subject to change; specifications can be changed without further notice.
Dvize bv Witte Vlinderweg 51,1521 PS Wormerveer, Nederlandinfo@dvize.eu, www.hyundai-air-nl.com Dvize bv Witte Vlinderweg 51 1521 PS Wormerveer info@dvize.eu Nederland www.hyundai-air-nl.com Licensed by Hyundai Corporation Holdings, Korea Imported/Distributed by Dvize bv, The Netherlands
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>