VISUAL COMFORT TOB 5738 Thomas O’Brien Fitz Large Pendant In Polished Nickel Installation Guide

VISUAL COMFORT TOB 5738 Thomas O’Brien Fitz Large Pendant In Polished

Nickel

NOTICE:
This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with the construction and operation of it, as well as the hazards involved. Inspect items and contents carefully. If any damage or defect is found, do not install. Retain all packaging material until installation is complete and approved

TOOLS REQUIRED (NOT INCLUDED)

• Phillips Screwdriver
• Slotted Screwdriver
• Wire Cutters
• Wire Strippers

ASSEMBLY INSTRUCTIONS

1. Carefully remove all parts from the box. Place on a clean, soft surface.

2. Remove mounting plate (B) from the canopy (F) by removing collar
   ring (G).

3. Install mounting plate (B) to the junction box and secure with mounting screws (C).

4. Feed electrical and ground wires through bottom rod (J) and connect to fixture (K). Repeat for middle rod (I), connecting to the bottom rod (J).

5. Continue feeding wires through collar ring (G) and canopy (F).

6. Holding fixture upright, slide collar ring (G) and canopy (F) down and rest on the fixture (K). Then connect the top rod (H) to the middle rod (I). NOTE: Slide components down slowly to avoid damage.

7. Hang fixture swivel ball (O) to the center of mounting plate (B) and secure set screw (Q) using a provided wrench (P).

8. Cut excess wires, being sure to leave enough to reach the junction box. Separate wires, and strip insulation on each 5/8”.

9. Wrap fixture ground wire (bare copper) around the green grounding screw (see diagram 1). Tighten. Continue fixture ground wire and connect to supply ground wire (usually green or bare copper) using wire nut (A).
   NOTE: It is imperative that the fixture is grounded.

10. Connect fixture neutral wire (white) to the supply neutral wire (usually white) using wire nut (A).

11. Connect fixture hot wire (black) to the supply hot wire (usually black) using wire nut (A).
    CAUTION: Do not reverse the hot and neutral connections.

12. Make sure all wire connections are tight, then carefully tuck them into the junction box.

13. Install canopy (F) to mounting plate (B) and secure with collar ring (G).

14. Install the light bulb into the socket.

15. Install glass shade (D) to bracket (M) and secure by bending metal taps (E).

16. Remove threaded caps (N) from screws (L), then install metal shade bracket (M) to bottom of fixture (K) and secure with screws (L) using threaded caps (N).

Care Instructions: Clean only with a soft dry cloth or feather duster. Do Not use abrasive or chemical agents.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>