CLAS OP 0053BL Pneumatic Vacuum Brake Bleeder Instructions

OP 0053BL PNEUMATIC VACUUM
BRAKE BLEEDER
clas.com

OP 0053BL Pneumatic Vacuum Brake Bleeder

WARNING
Before returning this product for any reason (installation problem, instructions for use, breakdown, manufacturing problem…), please contact us.
Contact :
You can reach us by mail sav@clas.com or by phone +33(0)4 79 72 69 18 or go directly to our website clas.com
If you have changed your mind regarding your purchase, please return this product before you attempt to install it.

SAFETY ADVICE

1. Brake systems should be maintained by qualified personnel only!
2. Secure your vehicle against unintended movement.
3. Always follow the manufacturer’s recommendations.
4. Do not leave brake fluid out in the open. Brake fluid is hygroscopic which means it will absorb humidity out of the air. The existence of water in brake fluid will decrease its boiling point and may cause a total malfunction of your brake system.
5. Always use new and unused brake fluid; used and worn out brake fluid may cause a total malfunction of your brake system.

INSTRUCTIONS

1. Connect the professional brake bleeder to the compressed air supply.
   Note: Do not operate the brake pedal while bleeding the brake.

2. Apply bleeding adapter to the nozzle on the brake caliper respectively on the wheel cylinder and open the nozzle slowly.
   Note: When opening the nozzle too far, surrounding air might be sucked into the system via the nozzle thread. When opening the nozzle not far enough, the brake fluid might not flow well or maybe not at all.

3. By activating the bleeder’s trigger you create a vacuum and the brake fluid will be sucked into the drain canister.
   Note: When working on vehicles with a load-dependent brake system on the rear axle, the brake fluid might not flow well or maybe not at all. In this case follow the manufacturer’s advice.

4. As soon as the brake fluid flows bubble-free through the clear hose, close the nozzle and take off the bleeding adaptor.

5. Repeat these steps on each brake caliper or wheel cylinder.
   Note: While bleeding the brake, there must be a sufficient amount of fresh brake fluid in the refilling canister. Otherwise air will be sucked into the brake system and you will have to bleed the brake again.

6. Check the filling level in the brake fluid reservoir of your vehicle after finishing the bleeding and refill if necessary. Close and seal the reservoir and check all nozzles for impermeability.

MAINTENANCE: We recommend a thorough cleaning after each use.

CLAS Equipements
ZA de la CROUZA
73800 CHIGNIN
FRANCE
Tél. +33 (0)4 79 72 62 22
Fax. +33 (0)4 79 72 52 86
OP 0053BL
PNEUMATIC VACUUM BRAKE BLEEDER
If you need components or parts, please contact the reseller.
In case of problems, please contact your authorized technician.

Documents / Resources

| CLAS OP 0053BL Pneumatic Vacuum Brake Bleeder [pdf] Instructions
OP 0053BL Pneumatic Vacuum Brake Bleeder, OP 0053BL, Pneumatic Vacuum Brake Bleeder, Vacuum Brake Bleeder, Brake Bleeder, Bleeder
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>