luminii LETO 11 WM Wet Wall Mount Instruction Manual
- June 4, 2024
- luminii
Table of Contents
luminii LETO 11 WM Wet Wall Mount
IMPORTANT INSTRUCTIONS
Read and follow these instructions before installing or maintaining this product
- Install bracket so that fixture lines up with the desired orientation.
- This product is suitable for DAMP OR WET LOCATIONS
- Make sure this product is NOT on the same circuit as inductive loads, (e.g. fluorescent bulbs, discharge bulbs, ventilation fans, etc…)
- Allow air to flow freely around the fixture
- Do not switch on line voltage until all wiring is complete
- Incorrect wiring will result in irreparable damage to LED and power supply
- This product should only be installed by a licensed electrician
Warranty
- This product must be installed in accordance with all applicable installation codes and ordinance
- Limited five (5) years warranty
- Warranty is void in the eventuality of unauthorized modifications and/or improper use
Installation
- Mount bracket to wall or junction box. Make sure the tabs are level horizontally.
- Make DC electrical connections. Aline Leto 11 WM Wet to the tabs on the bracket.
- Push Leto 11 WM Wet tightly against the wall. Secure in place using the 2 set screws.
- Apply silicone around the edge between the wall and the canopy. Apply silicone to each set screw hole as well.
- Be sure to fill the area shown above. Keep the bead smooth with no air gaps.
403-216-7043 | info@sensolighting.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>